CD_Programs

温度显示仿真图，利用proutes软件仿真(Temperature display simulation map, use proutes software simulation)

用51单片机读取AD芯片7135，并显示在1602上，7135是一个高精度低速的AD芯片(With 51 MCU read AD chip 7135, and displayed in 1602, 7135 is a high-precision low-speed AD chip)

For this project you need a 3.7v power supply that prepared by LM317 regulator. So you need MAX232 for connect uart to pc .my AVR chip project is Mega8 that you can program on any Avr chip have 2kbyte rom. In bascom spi hardware don’t work correct, so I have to software spi ,but the software spi configure have low speed into hardware spi.

电子称重的实现首先是通过压力传感器采集到被测物体的重量并将其转换成电压信号。输出电压信号通常很小，需要通过前级信号处理电路进行准确的线性放大。放大后的模拟电压信号经AD转换进入主控单片机中，再将结果显示在人机界面。(The realization of electronic weighing is firstly to collect the weight of the measured object through a pressure sensor and convert it into a voltage signal. The output voltage signal is usually very small, which requires accurate linear amplification through the front signal processing circuit. The amplified analog voltage signal is converted into the main MCU by AD, and the results are displayed in the man-machine interface.)

profibus dp 从站 软件通信协议的实现(profibus dp)

C8051F310 IO按键指示灯驱动程序

说明：  运用MATLAB编程，制作属于自己的时钟，高逼格记录时间的流逝(Using MATLAB programming to make their own clocks and record the passage of time with high-precision grids~)

说明：  卡尔曼滤波-很不错，使用于姿态校正，使用陀螺仪和加速度计来进行计算(Kalman filter- a very good posture correction used, the use of gyroscopes and accelerometers to calculate)

本文讲述了细分驱动技术的原理，重点介绍了细分驱动控制系统的设计方法，设计了一套传统细分驱动系统的设计方案，在此基础上，本文进一步介绍了L297、L298两块芯片，采用这两块芯片构成步进电机的驱动电路，应用DAC0832实现D/A转换，采用精简指令集单片机AVR作为脉冲产生器，对步进电机的工作过程进行控制，最终组成电机细分数可选的驱动控制系统。(failed to translate)

for ti cc2650 chips sensor