A-picture-in-a-letter

system identification and DMC control of a debutanizer plant

The PAPR of QAM system is plotted against Complementary cumulative distribution function

可以很方便的用matlab来编写一维二维三维的莫比乌斯带的图案(Can easily use matlab to write a one-dimensional two-dimensional pattern of three-dimensional Mobius)

通信系统仿真原理与无线应用第四张全部程序(Communication System Simulation Principle and wireless applications fourth all procedures)

智能控制（刘金琨版）第10章第3题课后练习MATLAB程序(Intelligent Control (Hangzhou Press Edition) Chapter 10 Homework Question 3 MATLAB program)

说明：  利用matllet算法的小波消噪程序 噪音区间可以自定义(Matllet algorithm using wavelet denoising process noise interval can customize)

说明：  QPSK调制的Matlab程序。包含了QPSK调制及误码率分析。可以调制一随机产生的序列来分析误码率，也可以调制一幅图像来分析误码率。(QPSK modulation of the Matlab program. Contains a QPSK modulation and BER analysis. Can be modulated to a randomly generated sequence analysis of BER, an image can also be prepared to analyze the error rate.)

Filter Design using MATLAB

双幅线算法的研究，从新修正并改进了算法，可以仿真编程(matlab fft)

.已知某炉温控制系统，要求温度保持在600℃恒定，针对该控制系统有以下控制经验： （1）若炉温低于600℃，则升压，低的越多升压越高； （2）若炉温高于600℃，则降压，高得越多降压越低； （3）若炉温等于600℃，则保持电压不变。 设模糊控制器为一维控制器，输入语言变量为误差，输出为控制电压。输入输出变量的量化等级为7级，取5个模糊集，试设计隶属度函数误差变化划分表，控制电压变化划分表和模糊控制规则表。 (Known for a temperature control system that requires a constant temperature is maintained at 600 ℃, the following control experience for the control system: (1) If the furnace temperature is below 600 ℃, the step-up, the more the higher the lower the boost (2) if the furnace temperature is higher than 600 ℃, the blood pressure, high blood pressure, the lower the more (3) If the furnace temperature is equal to 600 ℃, then keep the voltage constant. Set of fuzzy controller for one-dimensional controller, input linguistic variables for error, the output control voltage. Input and output variables of quantization levels for seven, take five fuzzy sets, membership function test design error variance divided table, partition table and the control voltage variation fuzzy control rule table.)