DVB-T-simulink-simulation

本试验是用数字基带处理方法来实现调试期算法的基带硬件实验。 通过用软件matlab进行了GMSK相位路径和眼图的仿真,之后对任何一种五位随机码，每周期八次的任一抽样时刻，和任一相位区域(0、1、2、3)的任一组合，计算出相位 ，并对 以及 进行1024位的量化、编码成10位二进制码表。进一步利用matlab从上述的码表得出GMSK基带波形的眼图，和理论上计算的眼图比较，一致性很好。(眼图主程序) (This test is a method to realize the digital baseband processor debugging phase algorithms with hardware-based experiments. By using the software matlab a GMSK phase path and the eye diagram of the simulation, after any one of five random code, eight times per cycle of any one sampling time, and any one-phase region (0,1,2,3) of any combination of one to calculate the phase, and 1024 as well as quantitative, encoded into a binary code table 10. Further use of matlab code from the above tables GMSK baseband waveform eye diagram and eye diagram theoretically compared to a good consistency. (Eye diagram of main program))

数字基带传输系统的matlab仿真，用4种码型(Digital baseband transmission system matlab simulation, with four kinds of code-type)

关于Q元LDPC码的C++仿真程序，绝对正确，应经调试过了……请参考(Q yuan LDPC code on the C++ Simulation program, is absolutely correct, shall be subject to adjustment after a ... ... please refer to)

可以正确仿真出FBG布拉格光纤光栅的反射光谱(The reflection spectra of FBG Bragg gratings can be simulated correctly)

一种新的压缩传感技术,用matlab进行的仿真(A new compressed sensing technology, using matlab simulation carried out)

说明：  V5.2接口一致性测试规范，是V5.2接口测试的指导性文件，对V5开发人员有较大帮助(V5.2 interface conformance test specification, V5.2 interface test the guiding document, the right V5 developers have more help)

说明：  我在美国公司用的CA code GPS toolbox(this is matlab toolbox I write and use in my company for simulating a CA code in GPS)

前后向平滑算法：算法的原理很简单，以五点三次平滑为例。取相邻的5个数据点，可以拟合出一条3次曲线来，然后用3次曲线上相应的位置的数据值作为滤波后结果。简单的说就是 Savitzky-Golay 滤波器 。只不过Savitzky-Golay 滤波器并不特殊考虑边界的几个数据点，而这个算法还特意把边上的几个点的数据拟合结果给推导了出来。(Before and after the smoothing algorithm: the principle of the algorithm is very simple, to 5.3 times smooth as an example. Take the adjacent five data points, you can fit out a curve 3 times, and then use the corresponding position on the third time the data value as the filtered results. Simply said is the Savitzky-Golay filter. However, the Savitzky-Golay filter does not specifically consider several data points of the boundary, and this algorithm also specifically to the edge of a few points of the data fitting results derived.)

一个DQPSK信号接收与发送部分的软硬件设计。其中IF=70MHZ，信息速率=10MBS，采用带通信号采样技术，数字正交解调和调制技术。NCO频率分辨率为32位，相位分辨率为10位(A DQPSK signal reception and transmission part of the software and hardware design. Which IF = 70MHZ, information rate = 10MBS, the use of bandpass sampling technique, the digital quadrature demodulation and modulation techniques. NCO frequency resolution of 32, phase resolution of 10)

这是一段求信息量的C++程序,对输入的一组数据进行求和,及最终算出其信息量和信道容量(This is for the amount of information for some of the C++ Procedures, a group of input data summation, and finally calculate the amount of information and channel capacity)