Y868460[1]

m伪随机序列Matlab源代码，很不错，值得看看(m pseudo-random sequence Matlab source code, very good, we can look at)

基于C语言的压缩感知程序，目前大部分程序都是基于matlab的，这个代码可以作为参考。(C-based compressed sensing program, most programs are based on the current matlab, this code can be used as a reference.)

利用PO修正MM-UTD计算机载波导缝隙天线阵的方向图(Use PO correction MM-UTD computer containing waveguide slot array antenna pattern)

说明：  用C写的很好用的EQ均衡器，可以输出个音频端的值(eq)

vc 与 matlab的混合编程，关于调用，执行(VC AND MATLAB )

悬置功能计算的，能量解耦的方法，优化及其位移的计算(The calculation of suspended function, energy decoupling method, optimization and calculation of displacement)

设雷达信号是码宽为0.5微妙，中心频率是10MHz的7为巴克码2PSK信号，接收的雷达回波中频采样频率为为40MHz，中频进行正交下变频。假设在13.5km处有一个点目标，仿真该雷达的脉冲压缩处理。 已通过测试。 (Let the radar signal is yards wide 0.5-subtle, the center frequency of the the Buck the code 2PSK signal, the received radar echo IF sampling frequency of 10MHz to 40MHz, IF quadrature down-conversion. Assuming the 13.5km at a point target simulation of the radar pulse compression processing. Has been tested.)

说明：  Programming technique for matlab

该程序初步实现了M序列的生成，并且详细地进行了频域法的系统辨识分析。(The program is the initial realization of the M-sequence generation, and detail the frequency domain method of system identification analysis.)

内含五个程序 1.zoeppritz Aki K I 和Richards P G的纵波近似程序 2.地震记录合成程序 3.大地电磁一维正演程序 4.雷克子波合成程序 5.地震反射系数生成程序(1.zoeppritz Aki KI and Richards PG longitudinal wave approximation procedures 2. Seismogram synthesis program 3. Magnetotelluric one-dimensional forward modeling program 4. Ricker wave synthesis procedure 5. Seismic reflection coefficient generator)