-
carpim
Product table for numbers in matlab
- 2011-05-29 17:50:29下载
- 积分:1
-
generation
产生固定周期数的正弦脉冲信号
使用该函数时必须预先设定如下参数:正弦波的频率Fp,构成输出脉冲的正弦波的周期个数Nc,脉冲幅度A每个周期的采样点数smp。函数有两个输出:脉冲波形,以响亮sinpulse的形式输出,采样周期dt。(Produce a fixed number of cycles of the sine pulse signal
Use this function must be pre-set the following parameters: a sine wave of frequency Fp, constituting the output of the pulse cycle of the sine wave of the number Nc, the sampling points for each cycle of the pulse amplitude A smp. The function has two outputs: output pulse waveform, the a loud sinpulse form, the sampling period dt.)
- 2013-04-15 16:03:25下载
- 积分:1
-
grey--model--simulink
该图片介绍了灰色预测模型的simulink的建模方法(This picture discribes the method of grey prediction model about simulink.)
- 2016-11-04 10:41:44下载
- 积分:1
-
Polar Code
说明: 该代码从polar信道编码到SC译码算法在BEC信道上进行全面仿真。仿真结果是基于不同码率的误块率。(The code from polar channel coding to SC decoding algorithm is simulated in BEC channel. The simulation results are based on different bit rate block error rate.)
- 2021-03-17 14:39:20下载
- 积分:1
-
Tsmart
完成智能天线的T程序仿真,通过仿真可以输出天线的MUSIC算法的结果(Smart antenna to complete the T process simulation, simulation can be output through the antenna of the results of the MUSIC algorithm)
- 2009-05-20 10:35:47下载
- 积分:1
-
SSFM
用分布傅里叶计算硅波导中的非线性薛定谔方程,考虑硅波导中色散及非线性损耗(solution of NLSE(two pulses propagate in silicon waveguide) using split step fourier method)
- 2013-11-27 11:28:48下载
- 积分:1
-
PQcontrol
三相并网逆变器,电压环和电流环双环控制,电流环参考值有功率控制,实现PQ控制(
制
Three-phase grid-connected inverter, voltage loop and current loop dual-loop control, current loop power control reference values are realized PQ control)
- 2016-02-12 01:58:05下载
- 积分:1
-
SVPWM
vpwm的matlab仿真主要利用matlab进行svpwm(Matlab simulation based on SVPWM mainly utilizes Matlab to process park transission, park anti transition, wave output and etc produced by SVPWM.)
- 2010-06-04 10:06:45下载
- 积分:1
-
wavelift
暂时只支持jpeg2000支持的 cdf97 和spline53
可以这样来测试:
x=imread( E:studyjpeg2000imageslena.tif )
% see the decomposition coefficients
y=wavelift(x, 1, spl53 ) using spline 5/3 wavelet
figure subplot(1,2,1) imshow(x) subplot(1,2,2) imshow(mat2gray(y))
% see the reconstruction precision
yy=wavelift(x, 5) using cdf 9/7 wavelet
ix=wavelift(yy,-5) inverse
sum(sum((double(x)-ix).^2))
(only temporary support jpeg2000 support cdf97 and spline53 this can be measured Examination : x = imread (E : study jpeg2000 images lena.tif)% see the d ecomposition coefficients wavelift y = (x, 1, spl53) using spline 5/3 wavelet figure subplot (1,2,1) imshow (x) subplot (1,2, 2) imshow (mat2gray (y))% see the reconstructi on precision wavelift yy = (x, 5) using cdf 9/7 wavelet ix = wavelift (yy.-5) inverse sum (sum ((double (x)- ix). ^ 2)
- 2006-08-08 23:51:30下载
- 积分:1
-
xiaobobao
小波包去噪小波包去噪小波包去噪小波包去噪(Wavelet packet denoising wavelet packet denoising wavelet packet denoising wavelet packet denoising)
- 2011-05-18 16:06:23下载
- 积分:1