登录
首页 » matlab » huffmancode

huffmancode

于 2011-06-23 发布 文件大小:1KB
0 262
下载积分: 1 下载次数: 2

代码说明:

  对任意概率的输入,实现2元HUFFMAN编码的MATLAB(The probability of any input to achieve two yuan HUFFMAN coding the MATLAB)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • single_phase_grid_pv
    太阳能最大功率点跟踪,最后加一个单向逆变装置(The maximum power point of the solar tracking)
    2015-04-01 16:31:57下载
    积分:1
  • SolveOMP
    Orthogonal Matching Pursuit
    2011-02-03 03:19:04下载
    积分:1
  • matlabECG02
    说明:  心电信号仿真数学模型建立,包含心电图波形的检测(ECG simulation of mathematical model-building, including the detection of ECG waveforms)
    2009-08-18 09:41:53下载
    积分:1
  • ISM_MATLAB
    宽带信号的DOA估计算法,可以实现宽带信号的doa估计(doa estimation algorithm for wide signal )
    2015-10-28 10:42:22下载
    积分:1
  • shuzhifenxiMATLABI
    说明:  这是有关数值分析的MATLAB练习册程序,学习人员可以参考一下(This is a MATLAB workbook program for numerical analysis, which can be consulted by learners.)
    2019-03-02 20:39:01下载
    积分:1
  • Gbps-high-speed-channel-estimation
    Gbps高速无线通信的信道估计技术研究,硕士论文,很值得学习(Gbps high-speed wireless communication channel estimation techniques, Master' s thesis, it is worth learning)
    2012-06-15 21:32:35下载
    积分:1
  • codes
    i am uploading some matlab source codes
    2012-09-08 17:08:50下载
    积分:1
  • 光伏并网MATLAB模型
    一些入门的并网控制系统,含光伏和储能部分。(Some introductory networked control systems, including photovoltaic and energy storage)
    2021-05-08 11:08:35下载
    积分:1
  • bottom_up_segmentation
    这是TD算法的逆过程,首先将时间序列,划分为相邻点的短序列,当然此时的拟合误差为0,因为第一点和第二点的连线,原始点都落在线段上。将相邻两个线段连接起来,此时每条线段包含三个原始点,计算中间那个点的拟合误差。这样,所有这些三个点的线段中的中间点的拟合误差计算出来后,找出误差最小且误差小于阀值R的分段,作为第一条包含三个点的线段。 在上面的基础上,第一条分段同样的和相邻线段连接,然后计算每一条分段的拟合误差,再找出误差最小且小于阀值R的分段,作为第二个分段。依次方式循环,直到所有分段的拟合误差都小于阀值R,分段结束。 (This is the reverse process of TD algorithm, the first time series is divided into short sequences adjacent dots, of course fitting error is zero at this time, because the first and second points of connection, the original point fall line on. The two adjacent segments are connected, then each segment contains three original point, the intermediate fitting error calculated that point. Thus, after all these segments fitting error of three points in the intermediate point calculated to find the minimum error and the error is less than the threshold R segment, as the first line contains three points. Based on the above, the first segment and the adjacent line segment connecting the same, and then calculate a fitting error for each segment, and then find the smallest error and less than the threshold R segment, as the second segment . Followed by a cyclic manner until all segments fitting error is less than the threshold R, segment ends.)
    2021-03-20 16:29:18下载
    积分:1
  • fillnans
    FILLNANS replaces all NaNs in array using inverse-distance weighting between non-NaN values.
    2007-08-14 11:05:34下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载