登录
首页 » matlab » MATLAB6.5ApplicationInterfaceProgramming

MATLAB6.5ApplicationInterfaceProgramming

于 2007-03-14 发布 文件大小:9152KB
0 242
下载积分: 1 下载次数: 23

代码说明:

  MATLAB6.5接口编程(本人加了目录).(MATLAB6.5 Programming Interface (I added a directory).)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • shuxueruanjian
    《数学软件》实验指导书 实验一 matlab运算基础 实验目的: 熟悉matlab 编程环境,掌握建立矩阵的方法。 实验内容: (" Math software" guide book experiment experimental experimental one basic purpose of computing matlab: matlab programming environment familiar with the master set up the matrix method. Experimental contents:)
    2009-02-21 16:38:51下载
    积分:1
  • two_type_of_lowpass
    用firgr函数设计的两种类型的FIR低通滤波器,( minorder/minodd )边界频率fre_edge=[0 .345 .575 1]*pi 显示幅频特性(Firgr function design with two types of FIR low-pass filter, (' minorder/minodd' ) boundary frequency fre_edge = [0 .345 .575 1]* pi shows the amplitude frequency characteristics)
    2010-12-04 17:24:45下载
    积分:1
  • toph
    TopHat algorithm. The algorithm based on gray scale opening.
    2010-02-17 06:33:37下载
    积分:1
  • mqzz_sobel_dlg
    说明:  个人编写的基于matlab的sobel算子算法(Personal preparation of the matlab-based algorithm sobel)
    2009-07-30 09:26:18下载
    积分:1
  • MUSIC
    说明:  经典MUSIC算法仿真,并有信号相干情况下,采用前向以及前后向平滑技术估计波达方向。(Classical MUSIC algorithm simulation, and a signal coherent case, the forward and after smoothing technique to estimate DOA.)
    2011-04-15 09:35:38下载
    积分:1
  • mmo44
    261601《宽带无线通信技术》作业”第八题的相关解答 其中,“第八题单径瑞利四发四收VBLAST.doc”是第八题的解答过程 文件夹“均方误差关系曲线”存放的是产生比特信噪比均方误差关系曲线的相关源代码及仿真结果 文件夹“误码率”存放的是比特信噪比与误码率关系的相关源代码及仿真结果。(failed to translate)
    2013-05-03 18:11:11下载
    积分:1
  • Project_uGUI_map_file
    说明:  dfydrtyrt df d erzftg zer ter ter
    2019-01-09 18:49:18下载
    积分:1
  • phase
    利用matlab计算电压与电流相位差,定A相电压相位为0.(Matlab calculated using voltage and current phase, phase-phase voltage set A to 0.)
    2011-05-29 19:13:37下载
    积分:1
  • ICEE-574
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:54:09下载
    积分:1
  • matlab
    基于matlab的光学实验模拟,能很好体现matlab在这方面的优点(Optical-based experimental simulation matlab, matlab reflected well the advantages in this area)
    2010-12-25 01:24:30下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载