Discriminadorareas

various matlab simulink good

本文件夹中包含了多种回归算法，用matlab编写(This folder contains a variety of regression algorithm using matlab to prepare)

采用Matlab编写菜单程序,着重强调matlab汉字处理功能(Using matlab language to write a menu)

temperature data logger-The temperature data logger is a device to read temperature and store persistent temperature and corresponding timestamp data into Flash memory. The collection of temperature data can be retrieved, and analyzed after being logged. The temperature data logger is commonly used for monitoring environmental data and shipments of temperature sensitive products such as foods, pharmaceuticals, and some chemicals. In particular, temperature data logger can operate as a stand-alone device and put in a variety of locations including office, laboratory or geographical location such as mountains, deserts,… and in manufacturing line in industry to collect temperature data over a defined period of time. It is also small enough and portable to be integrated with shipping container or directly attached to products which can be degraded due to exposure to temperature extremes to monitor their temperature

Modulation test for OFDM : This is a set of five (5) codes about COFDM (Coded Orthogonal Frequency Division Multiplexing) and coding schemes such as Convolutional, BCH, Reed Solomon (RS) and Low Density Parity Check (LDPC). The study uses an OFDM signal over an AWGN Channel with white Gaussian noise model, and calculate the Bit Error Rate wich is plotted.

蒙特卡洛模拟蒙特卡罗模拟因摩纳哥著名的赌场而得名。它能够帮助人们从数学上表述物理、化学、工程、经济学以及环境动力学中一些非常复杂的相互作用。 数学家们称这种表述为"模式"，而当一种模式足够精确时， 他能产生与实际操作中对同一条件相同的反应。但蒙特卡罗模拟有一个危险的缺陷: 如果必须输入一个模式中的随机数并不像设想的那样是随机数， 而却构成一些微妙的非随机模式， 那么整个的模拟(及其预测结果)都可能是错的。(Monte Carlo simulation)

电力系统中小电流接地故障仿真，模拟了10KV系统中性点不接地、中性点经消弧线圈两种状态下的电压、电流波形。(Power system small and medium-current ground fault simulation, simulation 10KV system ungrounded, under the two states of the neutral point arc suppression coil voltage and current waveforms.)

加窗函数，针对大家不知道如何加窗提出来的一个例子(an example of window function )

16-QAM matlab program, it can be run(16 QAM Matlab)

说明：  智能控制仿真GUI界面，对离散化的受控对象进行不同方式的控制（包括传统PID控制、模糊PID控制、神经PID控制和专家及仿人智能控制），然后通过分析不同条件下的单位阶跃响应指标，比较各控制方式之间的差异及控制特点。(intelligent control GUI)