simulate

这对于学习matlab是非常有用的，是相当有用的。要相信的(This is very useful for learning matlab is quite useful. To believe)

说明：  虫口模型的短小程序，有用的下，没用的别下，看看最好(Insect population model of the short program, useful, the useless do next, take a look at the best)

复杂网络matlab工具包，很好用的哦,用了会说好的，方便易懂(complex network matlab)

说明：  用于图像拼接，图像序列的柱面全景拼接算法，matlab仿真程序(For image mosaic, image sequence cylindrical panorama stitching algorithm, matlab simulation program)

数模中的钻井问题的matlab源码，需要的下！(few Die drilling Matlab source of the problem, it needs under!)

改算法描述了基于最小均方误差的多用户信号检测(MMSE,MUD,CDMA)

space Time Block code

说明：  实现功能： （1）完成简单的加、减、乘、除、乘方（x^y）； （2）能够完成十进制数到二进制和16进制的转化； （3）在上述基础上能够实现存储计算的结果，并能够在后续应用中调出，同时能够实现输错了删除的功能；(Implementation function: (1) Complete simple addition, subtraction, multiplication, division and multiplication (x ^ y); (2) It can complete the conversion from decimal to binary and hexadecimal; (3) on the basis of above, the result of storage calculation can be realized, and it can be transferred in subsequent applications, and at the same time, it can achieve the function of error deletion.)

说明：  matlab使用BP网络的例子,使用Levenberg Marquardt算法提高训练速度,效果不错(use Matlab BP example, the use of Levenberg Marquardt algorithm to improve training speed, good results)

本程序是矩形波的产生。第零步定义了要产生的波形的所有特征参数，矩形波的持续时间WIDTH，矩形波的采样点数POINTS,载波频率为F0，这个频率的最终引入是便于使用RF频率发射波形。第一步包括产生矩形波，并将其调制到RF上，注意，产生的信号的持续时间是矩形波宽度的5倍，这样，总的采样点数就是5*POINTS。同时还应注意，如果要产生一个基带信号，必须设置T0=0.第二步是画出所产生矩形波的源代码。( This procedure is rectangle wave production. Step to produce stage defined the waveform of all characteristic parameters, the duration of the rectangle wave WIDTH, rectangle wave sampling POINTS POINTS, carrier frequency F0, this frequency for the ultimate introduction is easy to use RF frequency emission waveforms. The first step including generating rectangle wave, and modulated to RF, attention, produce the duration of the signal is five times the width of rectangle wave, so, overall sampling POINTS is 5* POINTS. Also, note that if you want to produce a baseband signals must set T0 = 0. The second step is to draw a rectangular wave generated by the source code. )