-
sift-0.9.17.tar
特征点提取的Matlab程序,主要用于多视角的特征点提取,可以抗尺度变换(Matlab feature point extraction process, mainly used for multi-angle feature points extraction, can be anti-scaling)
- 2009-05-02 22:35:39下载
- 积分:1
-
Tank2
说明: 主要包括了用gui设计的计算机界面,能通过控件进行计算(including the use gui computer interface design, control through calculated)
- 2006-05-15 23:44:34下载
- 积分:1
-
QualityGuidedUnwrap2D
INSAR合成孔径干涉雷达相位解缠经典算法 -质量图引导法(INSAR synthetic aperture radar interferometry phase unwrapping algorithm - classic quality map to guide law)
- 2015-11-25 20:59:27下载
- 积分:1
-
QAMDemodule
QAM,很辛苦 ,很辛苦的,还再加上很辛苦(QAM, very hard, very hard, but also coupled with the very difficult)
- 2008-05-08 22:38:10下载
- 积分:1
-
TS_CHANNEL_656
利用ITU656接口传输数据流的方法!已得到应用!(ITU656 interface transfer data streams using the method! Has been applied!)
- 2010-02-23 14:16:18下载
- 积分:1
-
Rayleigh_Doppler_singlePath
使用matlab编写的仿真带多普勒频移的单信道模型(Prepared using the matlab simulation with Doppler shift of the single-channel model)
- 2007-10-15 16:35:06下载
- 积分:1
-
Genetic-neural-network
Used for mathematical modeling neural network training get intelligent algorithms
- 2012-03-20 23:39:06下载
- 积分:1
-
电源
说明: clllc开关电源,pi闭环控制,参数已经设置好,具体计算有相关论文,2018a版本的matlab(Clllc switching power supply, PI closed-loop control, parameters have been set, specific calculation has related papers, 2018a version of MATLAB)
- 2020-12-08 17:47:02下载
- 积分:1
-
windfarm_synmc-psl
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:52:32下载
- 积分:1
-
ch2
Statistical Analysis with Practice Problems
- 2015-01-26 02:47:43下载
- 积分:1