ARMArchitectureReferenceManual2ndEdition)

这是我自己写的用ARM7的SPI驱动LCD的程序 该显示屏的控制器为NT7532(This is what I wrote it myself with the ARM7 SPI-driven procedures of the LCD display controller for NT7 532)

硬件平台：STM32F401板子 软件平台：Keil5 功能：实现不同占空比的PWM波输出，通过按键切换输出模式（25%，50%，75%三种占空比模式）同时外接数码管显示当前模式（1，2，3）(Hardware platform: STM32F401 board Software platform: Keil5 Function: realize PWM wave output with different duty ratio, switch output mode by key button (25%, 50%, 75% three duty ratio mode) and display current mode (1, 2, 3).)

Energy storage system-based power control for grid-connected wind power farm

基于STM32F103ZE系列单片机的声源定位程序，使用LCD12864显示声源位置(Sound source localization program based on STM32F103ZE Series MCU, using LCD12864 to display the location of sound source.)

匿名飞控领航者基于stm32f407制作的飞控 用于控制四旋翼无人机(Anonymous Flight Control Pilot Based on STm32f407 Four-Rotor Unmanned Aerial Vehicle for Control)

说明：  采用89C51+DS1820+数码管+蜂鸣器DS1820设置为12位精度，环境温度超过Alarm值 蜂鸣器报警，超过40度 继电器启动 ，Alarm值可通过按键自由设定 (With 89C51+ DS1820+ DS1820 digital control+ buzzer set to 12-bit accuracy over temperature buzzer alarm Alarm value, more than 40 degrees relay start, Alarm value can be set freely by key)

LPC2378 ARM微处理器PWM输出源程序，可用ADS进行调试，该程序输出双边沿的PWM波形。(LPC2378 ARM microprocessor PWM output source, ADS can be used to debug the program along the PWM output waveform bilateral.)

ARM7 CAN收发代码 已经测试成功(CAN COMUNICATION!)

stm32f103zet6读写EEPRAM的例子，固件库是V3.5版本的(stm32f103zet6 read EEPRAM example, firmware version V3.5 library is)

基于STM32的2M U盘源码，对STM32的开发很有用(2M U disk on STM32 )