pricing-dual-channel

说明：  自己翻译的一篇最新外文文献《使用无需重建最佳探测器的宽带压缩传感认知无线电》(Own translation of a the latest foreign literature use without having to rebuild the best detectors broadband compressed sensing cognitive radio &quot )

模拟退火算法解决作业车间调度jobshop问题，以FT06问题为例说明，可产生甘特图，JSPmain是主函数。(Simulated annealing algorithm to solve the job shop scheduling jobshop problem to FT06 problem as an example, can produce a Gantt chart, JSPmain is the main function.)

HD-SDI信号的特征....................................(Features HD-SDI signals)

MATLAB-based simulators for mobile robot Simultaneous Localization and Mapping

在一种变步长LMS 算法的基础上，引进动量因式，提出了一种新的改进LMS 的算法。新算法整体性能优 于变步长LMS 算法以及LMS 算法。通过理论分析，比较了新的算法和变步长LMS 算法以及LMS 算法的收敛性 和稳态性，提出了一种设想以提高新算法的稳态性。仿真试验证明了新算法的优越性以及设想的在仿真条件下的正 确性。(In a variable step size LMS algorithm, based on the introduction of momentum factor, a new improvement of LMS algorithms. The overall performance of the new algorithm is superior to variable step size LMS algorithm and LMS algorithm. Through theoretical analysis, comparing the new algorithm and variable step size LMS algorithm and LMS algorithm convergence and steady-state, and proposes a new algorithm is envisaged to enhance the steady-state nature. Simulation tests proved the superiority of the new algorithm, as well as envisaged under the conditions in the simulation is correct.)

用MATLAB实现的基4FFT算法的程序，输入一个长度为16的序列，得到DFT的频谱(Implemented with the MATLAB-based algorithm 4FFT program, enter a sequence of length 16 obtained DFT spectrum)

这是免疫算法。这个算法几乎与遗传算法一样，只是多用了一个免疫函数 免疫算法是遗传算法的变体，它不用杂交，而是采用注入疫苗的方法。(This is the immune algorithm. This algorithm and genetic algorithm is almost the same, but with a much immune function Immune algorithm is a variant of the genetic algorithm, it does not hybridize, instead of using the method of injecting the vaccine.)

基于四边单元速度传热问题程序,入门程序，简单易懂，适合初学者对该方法编程的一个初步认识(Based on four sides of the unit rate of heat transfer procedures, entry procedures, easy to understand for beginners to the method of programming a preliminary understanding)

直接用手动产生单脉冲作为中断请求信号。 要求每按一次开关产生一次中断,在屏幕上 显示一次“TPCA Interrupt!”,中断10次后 程序退出(Directly by hand to produce a single pulse as an interrupt request signal. Each time you press the switch requires an interrupt is generated, show a TPCA Interrupt! On the screen, interrupted 10 times after the program exits)

matlab神经网络手册，想打印出来看的可以下载哦(matlab neural network handbook, would like to print out looking at can download Oh)