images_seg

一个利用Matlab仿真计算微带贴片天线底馈的程序(The use of Matlab simulation of a microstrip patch antenna fed at the end of the procedure)

说明：  防碰撞时隙ALOHA的matlab仿真算法(The matlab slot ALOHA anti-collision simulation algorithm)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

This bus abstraction is developed separately from drivers, so we need to check the version of the data structures we receive.

典型的正交匹配追踪OMP算法的matlab源程序，结构合理，简单易懂(Typical orthogonal matching pursuit OMP algorithm matlab source, reasonable structure, easy to understand)

non local mean filter commande example I =mat2gray(imread( eight.tif )) mn= 0 vr= 0.02 J = imnoise(I, gaussian ,mn,vr) add noise output=NLmeansfilter3(J,7,3,0.1)

matlab ods exercices

MATLAB高级讲义实例1(开环传递函数,二阶系统跃阶响应等)(MATLAB examples of senior notes 1 (open-loop transfer function, second-order system-yue-order response, etc.))

计算差分盒维数的matlab程序,是根据一篇文章写出来的，我也是下载的，看着不错就穿上来了，但还不知这样求维数对不对？(difference calculation of the box dimension Matlab procedure is based on an article written by, I also downloaded, Seeing good to wear it, but it has not requested such dimension that right?)

刚写完的VSNLMS程序，运行即可得结果。/可直接该参数 (VSNLMS just finish the procedure, it can run results./The parameters can be directly)