Ada_Boost

数字信号的传输：1、实现滚降系数分别为0，0.5，1时信号时域频域和功率谱密度以及眼图的波形，并比较异同。 2、对(2/4/8)PSK,DPSK通信系统进行蒙特卡罗仿真，通过功率谱密度、误比特率来比较他们的性能(采用最佳接收方式)。 (Digital signal transmission: 1, to achieve roll-off coefficients were 0,0.5,1 time domain when the signal frequency and power spectral density, as well as eye-diagram of the waveform, and compare the similarities and differences. 2, (2/4/8) PSK, DPSK communication system, Monte Carlo simulation, through the power spectral density, bit error rate to compare their performance (to adopt the best way to receive).)

用于结构在动力荷载作用下的时程分析,地震荷载，随即荷载均可，采用newmark方法(For structural time history analysis under dynamic loads, seismic loading, then the load can be, using the newmark method)

说明：  在matlab中经常用到的函数，用来实现利用3阶，44阶函数(Often used in matlab, used to realize the function of 3 order, 44 order function)

matlab 一维光栅本征模式展开方法用于计算光栅透射反射系数等(matlab one-dimensional grating eigenmode expansion method is used to calculate the reflection coefficient of the transmission grating)

提出了一个采用(2,1,7)卷积码+QPSK的中频调制解调方案,并在Xilinx公司的100万 门FPGA芯片上实现了该系统。该系统在信噪比SNR为6dB左右时可实现速率超过1Mbit/s、误码率 小于10-5的数据传输。 (Proposed a use of (2,1,7) convolutional code+ QPSK modulation and demodulation of the IF program, and in Xilinx' s FPGA chip one million on implementation of the system. The system SNR to 6dB signal to noise ratio at about the rate may achieve more than 1Mbit/s, less than 10-5 bit error rate of data transmission.)

数字图像处理，利用matlab开发环境进行编程实践。(Digital image processing using matlab to program development environment practice.)

数学工具软件matlab的学习资料，适用于初学者，内容实用。(Matlab mathematical tools of learning materials for beginners, the content useful.)

产生QPSK的简单程序，先产生0到3的随即数字，用这些数字产生相位，然后产生QPSK信号！(Get QPSK！)

这是一篇介绍C++BUILDE和MATLAB混合编程的文章，比较有参考价值(This is an article on C++ BUILDE and MATLAB programming mix of articles, compared with reference value)

滑模控制 目标轨迹跟踪 源代码，对初学者很有帮助(Sliding mode control target tracking source code)