70799061lpc

常用信道的实现原程序代码,可以用于通信系统性能的评估.(Original Program of the common channel)

提供简单的P2SP操作,初级学习使用,高手就不要下了(P2SP provide simple operation, the primary learning, masters, do not down the)

说明：  本文阐述了扩展频谱通信技术的理论基础和实现方法，利用MATLAB 提供的可视化 工具Simulink 建立了扩频通信系统仿真模型，详细讲述了各模块的设计，并指出了仿真建模 中要注意的问题。在给定仿真条件下，运行了仿真程序，得到了预期的仿真结果。同时，利 用建立的仿真系统，研究了扩频增益与输出端信噪比的关系，结果表明，在相同误码率下， 增大扩频增益，可以提高系统输出端的信噪比，从而提高通信系统的抗干扰能力。 (This paper describes the theory of spread-spectrum communication technology and implementation methods based on the use of visualization tools provided by MATLAB Simulink to establish a spread spectrum communication system simulation model, described in detail the design of each module, and pointed out that the simulation modeling to note problem. In the given simulation conditions, running a simulation program to obtain the desired simulation results. Meanwhile, the use of the simulation system to study the spreading gain and the relationship between the output signal to noise ratio, results show that the same bit error rate, increased spreading gain can increase the system output signal to noise ratio, thereby enhancing communication system disturbance.)

This module will calculate the electrical angle between two different signals (Normally current + Voltage). once the first siganl as a reference signal and once the second signal as a reference signal.

Packet-dropfunction functionfunction function

设计一个数字滤波器，在频率低于 的范围内，低通幅度特性为常数，并且不低于0.75dB。在频率 和 之间，阻带衰减至少为20dB。 (1)试求满足这些条件的最低阶Butterworth滤波器。(Design a digital filter, in the range of frequencies below the low-pass amplitude characteristic is constant, and not less than 0.75dB. Between the frequency and stop-band attenuation of at least 20dB. (1) Determine the lowest-order Butterworth filter to meet these conditions.)

说明：  本文件包含很好的模糊c-means的matlab仿真源码。(Fuzzy C-Means Clustering matlab code.,)

混沌系统在小周期状态进入混沌状态时的分岔图绘制，用MATLAB实现(MATLAB chaos)

对图像进行逐点计算，并且取最大值和最小值的差值作为该点新的灰度值。 在区别边缘点和非边缘点时，首先确定一个阈值T，若图像中像素点的新 值大于该门限值，则可以初步确定为边缘点，小于T的新值被判断为非边缘点.(Image point by point basis, and taking the maximum and minimum points of difference as the new gray value. Edge in the difference between point and non-edge point, first determine a threshold T, if the image of the new pixel value is greater than the threshold, you can initially identified as the edge point, the new value is less than T have been judged as non-edge point.)

关于f16的模型以及用四元素和常规办法配平。(About f16 model and with four trim elements and conventional approaches.)