-
DCT
Matlab code for image compression.
- 2013-02-08 14:56:32下载
- 积分:1
-
loss-calc._HT
matlab programme for loss calculation in HT line
- 2013-09-16 17:17:39下载
- 积分:1
-
simpgrad
simplex method
linear optimization method
- 2015-03-01 00:26:37下载
- 积分:1
-
6
说明: 模糊控制器的设计不依靠被控对象的模型,而是依靠控制专家或操作者的经验知识。模糊控制的突出优点是能够比较容易地将人的控制经验溶入到控制器中,但若缺乏一定的控制经验,很难设计出高水平的模糊控制器。而且,由于模糊控制器采用了IF-THRN控制规则,不便于控制参数的学习和调整,使得构造具有自适应的模糊控制器较困难。
自适应模糊控制是指具有自适应学习算法的模糊逻辑系统,其学习算法是依靠数据信息来调整模糊逻辑系统的参数。一个自适应模糊控制器可以用一个单一的自适应模糊系统构成,也可以用若干个自适应模糊系统构成。与传统的自适应控制相比,自适应模糊控制的优越性在于它可以利用操作人员提供的语言模糊性信息,对具有高度不确定因素的系统尤为重要(Fuzzy controller design does not rely on the controlled object model, but on control expert knowledge or experience of the operator. Highlight the advantages of fuzzy control is the ability to more easily control the experience of people integrated into the controller, but if a certain lack of control experience, it is difficult to design a high-level fuzzy controller. Moreover, since the fuzzy controller using the IF-THRN control rules is not easy to learn and adjust the control parameters, making construction more difficult adaptive fuzzy controller. Adaptive fuzzy control refers to the fuzzy logic system with adaptive learning algorithm, which is to rely on the data information learning algorithm to adjust the parameters of fuzzy logic systems. An adaptive fuzzy controller with a single adaptive fuzzy system configuration, you can also use a number of adaptive fuzzy system structure. Compared with the traditional adaptive control, adaptive fuzzy control advantages is that it can tak)
- 2015-04-21 16:50:50下载
- 积分:1
-
spatial_ZF_SIC
the code simulates the MIMO-OFDM spatial multiplexing with successive interference cancellation
- 2012-05-22 22:34:02下载
- 积分:1
-
animate
creating animation in matlab
- 2013-10-26 14:55:41下载
- 积分:1
-
cooperative-paper-with-matlab-code
An ad-hoc network with a sender, a destination and a third station act-
ing as a relay is analysed. The channels are modelled containing thermal
noise, Rayleigh fading and path loss. Di® erent combining methods and di-
versity protocols are compared. The amplify and forward protocol shows a
better performance than the decode and forward protocol, unless an error
correcting code is simulated. To combine the incoming signals the chan-
nel quality should be estimated as well as possible. Information about the
average quality shows nice bene¯ ts, and a rough approximation about the
variation of the channel quality increases the performance even more. What-
ever combination of diversity protocol and combining method is used second
level diversity is observed. The relative distances between the relay and the
stations has a large e® ect on the performance.
- 2015-02-28 15:30:52下载
- 积分:1
-
FM
说明: matlab,FM,通信系统,调制,解调,信号波形,频谱(matlab, FM, a communication system, a modulation, a demodulation, the signal waveform, the spectrum)
- 2012-11-21 21:45:24下载
- 积分:1
-
matlab-for-zigbee
ZIGBEE用MATLAB实现的源代码,可用于初学者用来学习和测试(Tree-Based Data Broadcast in IEEE 802.15.4 and ZigBee Networks.this is for new learners to use.)
- 2014-02-25 22:44:01下载
- 积分:1
-
fastica
基于fast独立分量分析方法实现盲源分离(Fast independent component analysis method based on blind source separation to achieve)
- 2011-01-09 16:57:26下载
- 积分:1