pierleetime

the project is used for the customers to learn something(important)

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

该程序可以实现网络拓扑图自动生成·是进行网络仿真拓扑图生成不可缺少的一部分，根据matlab下的程序修改过来，可以在VC环境下运行(The program can achieve network topology automatic generation is topological of network simulation is an indispensable part of, according to the procedure under Matlab modified, can run in VC environment)

说明：  车厢调度:程序对栈的任何存取（即更改，读取和状态判别等操作必须借助于基本操作。(Train scheduling: proceedings of the stack of any access (that is, changing, reading and state identification must be by means of basic operations such as Operation.)

verilog 源码 基于XILINX FPGA的ofdm通信系统基带设计(Experiment of digital signal processing: parallel filtering experiment code. I hope it will help.)

Arduino Uno Sketch to take measurements a strain gauge at precise depths into an elastic object. Interfaces the Uno with a micrometer using SPC and with strain gauge bridge circuit using Analog input pin. Tested to work on OSEPP Uno R3 Plus (Arduino Uno equivalent uC)

Denmark Technical University的大牛Hansen，第二版风力机空气动力学。(Denmark Technical University' s Daniel Hansen, the second edition of wind turbine aerodynamics.)

简单的二维码QRCode C_C++库使用演示源代码

数字聚类识别,基于图像模式识别-VC++技术实现书的基础上完成的(Number of cluster identification, image-based pattern recognition technology-VC++ based on the completion of the book)

最小二乘法曲线拟合，可以实现利用最小二乘法拟合曲线，并显示图形，操作简单。(Least squares curve fitting, can be achieved using least squares curve fitting and display graphics, easy to operate.)