decision

本文在阐述聚类分析方法的基础上重点研究FCM聚类算法。FCM算法是一种基于划分的聚类算法，它的思想是使得被划分到同一簇的对象之间相似度最大，而不同簇之间的相似度最小。最后基于MATLAB实现了对图像信息的聚类。( This paper describes the basis of cluster analysis methods and focus on the FCM clustering algorithm. FCM algorithm is a clustering algorithm based on division and the idea is to make it to the same cluster is divided into the biggest similarity between the objects, while the minimum similarity between different clusters. Finally, I realize the implementation of image information of the cluster based on MATLAB.)

数字通信系统的t-EBPSK的调制与解调，功率谱密度的绘制，以及误码率曲线(Digital communication system t-EBPSK modulation and demodulation, the power spectral density plotted, and BER curves)

利用非线性控制完成光伏并网逆变器的设计，设计中采用先进的反步法，介绍很好。(Using nonlinear control to complete the design of the photovoltaic (pv) grid inverter, adopted in the design of advanced reverse moves, the introduction is very good.)

Three-phase electric power is a common method of alternating-current electric power generation, transmission, and distribution.[1] It is a type of polyphase system and is the most common method used by electrical grids worldwide to transfer power. It is also used to power large motors and other heavy loads. A three-phase system is usually more economical than an equivalent single-phase or two-phase system at the same voltage because it uses less conductor material to transmit electrical power.[2] The three-phase system was independently invented by Galileo Ferraris, Mikhail Dolivo-Dobrovolsky and Nikola Tesla in the late 1880s.

An Experimental Investigation of SIMO, MIMO, Interference-Alignment (IA) and Coordinated Multi-Point (CoMP)

Bloc matching video processing

Runway detection using various fetaures.They are as follows Haralick feature,Basic features,Zernike moments,Circular-Mellin features,Fourier power spectrum,Gabor filters

A Modified Design of ACF Operation for Reducing PAPR of OFDM Signal

Matlab编写BP的入门程序，适合初学者！(Matlab entry procedures for the preparation of BP, suitable for beginners!)

calculation of power system loss