IAR-Refrence

msp430f149的adc采样(同时对八个点进行采样)!(msp430f149 the adc sampling (eight samples))

用的是时钟芯片pcf8583，可以正常显示时间,并带有有Proteus仿真，非常形象！，已通过测试。 (Is clock chip pcf8583, can properly display the time, and with Proteus simulation, the very image of , Has been tested.)

在STM32开发平台下，通过定时器的时钟配置，进行的PWM互补带死区的方波对电机进行控制。(Under the STM32 development platform, the PWM complementary square wave with dead zone is used to control the motor through the clock configuration of the timer.)

华为电路仿真培训教程，基于Hyperlyn平台仿真信号完整性电源完整性等高速PCB仿真设计平台(Huawei Circuit Simulation Training Course)

TTP913C Lcd Driver Demo Use C8051F330

STM32 IAP程序，keil开发环境，stm32iap应用，传输协议Ymode。(STM32 IAP program, keil development environment, stm32iap applications Transfer Protocol Ymode.)

单片机串口通信程序能和利用232串口计算机通信(Single-chip serial communication program and computer communications)

For this project you need a 3.7v power supply that prepared by LM317 regulator. So you need MAX232 for connect uart to pc .my AVR chip project is Mega8 that you can program on any Avr chip have 2kbyte rom. In bascom spi hardware don’t work correct, so I have to software spi ,but the software spi configure have low speed into hardware spi.

说明：  基于STM32F103单片机的串口通信测试源码(Serial Communication Test Source Based on STM32F103 Single Chip Microcomputer)

实现了UART的底层协议，加入了控制器，其波特率可以根据使用进行调整；发送模块、接收模块相互独立，互不影响。(Realization of the underlying protocol UART, joined the controller baud rate can be adjusted according to use transmission module, receiver module are independent of each other.)