mcr_100_m7

本程序是矩形波的产生。第零步定义了要产生的波形的所有特征参数，矩形波的持续时间WIDTH，矩形波的采样点数POINTS,载波频率为F0，这个频率的最终引入是便于使用RF频率发射波形。第一步包括产生矩形波，并将其调制到RF上，注意，产生的信号的持续时间是矩形波宽度的5倍，这样，总的采样点数就是5*POINTS。同时还应注意，如果要产生一个基带信号，必须设置T0=0.第二步是画出所产生矩形波的源代码。( This procedure is rectangle wave production. Step to produce stage defined the waveform of all characteristic parameters, the duration of the rectangle wave WIDTH, rectangle wave sampling POINTS POINTS, carrier frequency F0, this frequency for the ultimate introduction is easy to use RF frequency emission waveforms. The first step including generating rectangle wave, and modulated to RF, attention, produce the duration of the signal is five times the width of rectangle wave, so, overall sampling POINTS is 5* POINTS. Also, note that if you want to produce a baseband signals must set T0 = 0. The second step is to draw a rectangular wave generated by the source code. )

matlab在工程数学中的应用，基础教程(matlab in Maths Engierring)

这是一个完整的基于DWT变换的音频水印的例子，有助于学习音频水印(This is a complete audio watermarking based on DWT transform examples to help learn audio watermarking)

轨迹绘制。点击鼠标左键确定轨迹典型点，点击右键结束绘制。(Trajectory drawn. Click the left mouse button to determine the trajectory of a typical point, right-click to end the drawing.)

System identification with adaptive filter using full and partial-update Least-Mean-Squares

说明：  求模极大值的程序MATLIB源码,可以用此方法来判断时间序列的奇异点,并根据它来恢复信号.(modulus maxima for the procedure MATLIB source, you can use this method to determine the time sequence of singular point, and according to restore its signal.)

说明：  用于无线通信中天线仿真，matlab上的源代码，第三部分。(For wireless communications antenna simulation, matlab on the source code, the third part.)

rectifier 3 phasa close loop

Non Linear F16 Simulation using simulink and matlab

svm仿真,基于c语言的编写，可以用于matlab，python以及java等多种语言(simulation for svm)