trous

遗传算法实现背包问题的matlab代码，分享给大家(Knapsack problem genetic algorithm matlab code to share for everyone)

详细介绍了ofdm的发送模块、接收模块及信道估计(Ofdm described in detail the transmission module, receiver module and Channel Estimation)

注水算法是根据某种准则，并根据信道状况对发送功率进行自适应分配，通常是信道状况好的时刻，多分配功率，信道差的时候，少分配功率，从而最大化传输速率。本文运用matlab通过对注水算法在mino系统中的三种不同的情况下进行了仿真，比较出在小信噪比时，相同信噪比下利用CSI的功率注水算法获得容量优于未知CSI的平均功率分配算法；相同容量下已知CSI信噪比比未知CSI时的信噪比小3dB.当信噪比增大到一定程度时，功率注水算法所获得的信道容量将收敛到平均功率分配的信道容量。(Water flooding algorithm is based on certain standards, and according to the channel condition to adaptive allocation of sending power, usually is a good moment, channel situation more distribution power, channel is poor, less power distribution, so as to maximize the transmission rate. This paper USES matlab based on water flooding algorithm in Austin system of three different cases are simulated and compared in small SNR, under the same SNR use CSI power allocation algorithm for capacity is superior to the average power allocation algorithm of unknown CSI Same capacity known CSI signal-to-noise ratio than the unknown CSI small signal-to-noise ratio of 3 db. When the signal-to-noise ratio increases to a certain degree, the power allocation algorithm for channel capacity will converge to the average power distribution channel capacity. )

内模控制实现程序 基于MATLAB2010a环境下实现(Implement procedures based on internal model control environment to achieve MATLAB2010a)

直线检测及道路边缘检测，包括在DM6437上的实现(use the Hough Transform, Find Local Maxima, and Hough Lines blocks to find the longest line in an image. In the second step, the algorithm used for line detection will be the basis of a lane detection procedure. )

P & Q control of DFIG

simulik 仿真基础，讲解matlab/simulink中各种模块的应用(the basis of the simulink simulation)

DCT 音频水印 嵌入与提取 并进行攻击 (DCT SHUIYIN CHENGXU)

多天线环境下 使用注水法则 显示ergodic容量vs_snr(capacity_vs_snr_ by using waterfiling algorithm and in te multiple antenna condition)

几种基于小波变换的图像边缘提取程序，该程序中有对几种边缘提取程序进行比较，对于初学者或者小波变换编程刚入门的同学比较有帮助(Several wavelet-based image edge detection program that has several kinds of edge extraction procedures were compared, for beginners or transform just started programming more helpful to students)