communication-engineer

说明：  用MATLAB中的simulink搭建的基于LLC谐振的双向DCDC平台，采用PID控制环控制输出电压，波形较好。(MATLAB simulink built based on LLC resonant two-way DCDC platform, PID control loop control output voltage, waveform is good.)

matlab 数据文件I/O的实现方法，详细介绍matlab怎样从数据中读取数据以及保存数据至文件中。(how to load or save data using matlab)

本程序在MATLAB平台上实现了IIR滤波器的GUI设计，通过输入参数，即可在友好的界面上完成IIR滤波器的设计。(The program implemented on MATLAB platform GUI design of IIR filters, through the input parameters, can be completed in a friendly interface for IIR filter design.)

convertion spase RGB to HSV

system identification, m document based on idetification

ldpc码的编解码实现，使用高阶累积量对MPSK信号进行调制识别，未来线路预测,分析误差。( Codec ldpc code implementation Using high-order cumulants of MPSK signal modulation recognition, Future line prediction, error analysis.)

camera calibration that uses matlab for calibrating a camera. stereo vision technique. stereo pairs in the world coordinate and camera coordinate systems

Power flow analysis in two bus system

运用距离多普勒算法解决点目标成像问题，并且具有运动补偿功能(RD algorithm)

An ad-hoc network with a sender, a destination and a third station act- ing as a relay is analysed. The channels are modelled containing thermal noise, Rayleigh fading and path loss. Di® erent combining methods and di- versity protocols are compared. The amplify and forward protocol shows a better performance than the decode and forward protocol, unless an error correcting code is simulated. To combine the incoming signals the chan- nel quality should be estimated as well as possible. Information about the average quality shows nice bene¯ ts, and a rough approximation about the variation of the channel quality increases the performance even more.