登录
首页 » matlab » psnr

psnr

于 2010-05-25 发布 文件大小:4KB
0 283
下载积分: 1 下载次数: 17

代码说明:

  对一帧图像进行信噪比等因素的检测,比较实用(Image on a detection signal to noise ratio and other factors, more practical)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • matlab092
    数字电视信号发生器 有8种颜色 用MATLAB语句编写(Digital TV Signal Generator 8 colors prepared with the MATLAB statement)
    2009-11-18 00:27:24下载
    积分:1
  • Dejong2
    heuristic optimization
    2009-12-08 08:44:35下载
    积分:1
  • 项目4
    说明:  任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。 要求: 1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。 2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。 3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
    2019-05-13 09:39:41下载
    积分:1
  • tftb2002toolbox
    matlab工具包,非常有用的信号时频分析工具,stft,doppler(matlab toolkit, a very useful time-frequency analysis tools, stft, doppler)
    2009-10-21 21:13:09下载
    积分:1
  • MCTF
    对视频GOP进行MCTF,运动补偿时域滤波(Motion Compensated Time-domin Filter)
    2020-07-23 14:38:44下载
    积分:1
  • jb6
    本程序为CCK调制的MATLAB仿真程序,对于研究通信搞调制解调的人十分有用!~(err)
    2007-08-13 21:54:22下载
    积分:1
  • COS207MATLABCODE
    移动无线信道COS207模型MATLAB程序(Mobile radio channel model MATLAB program COS207)
    2009-05-08 18:46:14下载
    积分:1
  • OFDM_matlab
    OFDM系统的整个流程,用MATLAB编写的程序(The whole process of OFDM system, using MATLAB program )
    2014-08-19 14:00:11下载
    积分:1
  • URG04
    This is Laser Range Finder Communication source code. Device is Hokuyo URG 04 Series. URG-PC communication with SCIP 2.0. Contents is Next 1. Open Device 2. LRF SingleScan(Aquisition 682 data array at one scan) 3. Close Device
    2013-01-23 10:19:16下载
    积分:1
  • EMDtollbox
    EMD工具箱,里面有EMD变换工具箱及工具箱安装的具体操作(EMD toolbox, there are specific to the operation of the EMD transform and the installation of the toolbox toolbox)
    2015-03-13 21:04:22下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载