fds

说明：  用于形成网络方程所用的matlab程序，大概看一下就能懂(Matlab program used to form network equation)

Tesseral软件的说明书，该软件主要用于石油地球物理勘探。(Tesseral software instructions, the software mainly used for oil geophysical prospecting.)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

用PQ分解法实现潮流计算，程序已调试，打开即可用，学校课设必备(Realization of Power Flow Calculation by PQ Decomposition Method)

说明：  IEEE5节点经典算例程序，非常完整的潮流计算程序，对电力系统自动化专业的学生非常有用 (IEEE5classic example node procedure is a complete flow calculation procedure of the power system is very useful for students Automation)

毕业设计中做得无速度测速模型搭建毕业设计中做得无速度测速模型搭建(The graduation project is done without speed speed modelThe graduation project is done without speed speed model)

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)

abaqus焊接高斯热源子程序for文件，能运行的(ABAQUS welding Gauss heat source subroutine for file, able to run)

说明：  使用PSCAD搭建的三芯电缆模型,可用于相关仿真计算(Build the three-core cable model using PSCAD)

永磁同步电机模型参考自适应控制建模与仿真simulink，采用模型参考自适应( U6C38 u7C1 u6B1 u6B1 u7A1 u5A1 u5A2 U53C2 u8003 u81EA u9002 u5E94)