Principles-Of-Communication

Power Allocation for Underlay Device-to-Device Communication over Multiple Channels

EtherNet/IP Socket Interface(This publication describes the socket interface that you can use to program MSG instructions to communicate between a Logix5000 controller via an EtherNet/IP module and Ethernet devices that do not support the EtherNet/IP application protocol, such as bar code scanners,RFID readers,or other standard Ethernet devices.)

语音信号的采集与处理，数字信号处理课设，能量谱分析计算,小波包分析提取振动信号中的特征频率。( Acquisition and Processing of the speech signal, digital signal processing class-based, Energy spectrum analysis and calculation, Wavelet packet analysis to extract vibration signal characteristic frequency.)

pwm整流器的建模仿真，感应双馈发电机系统的仿真，复化三点Gauss-lengend公式求pi。( Modeling and simulation pwm rectifier Simulation of doubly fed induction generator system, Complex of three-point Gauss-lengend the Formula pi.)

Fiber Bragg Grating Book

S7-200以太网通讯图文教程 S7-200通过CP243-1或 CP243_1IT接入工业以太网。 S7-200以太网通信主要有以下几种方式： ★ S7-200之间的以太网通信 ★ S7-200与S7-300/400之间的以太网通信 ★ S7-200与OPC及WINCC的以太网通信 (S7-200 Ethernet communication graphic tutorial )

中文RFC文档，不用翻译，对大家学习很有帮助！(Chinese RFC documents, without translation, the right to study very helpful!)

OPTICAL COMMUNICATIONS MATLAB calls OptiSystem CO-OFDM.

该论文针对光纤传感系统，深入研究随机信号的互相关函数和基于AR模型的功率谱估计，设计出具有事件发生检测功能的传感器信号处理算法。(The paper for the fiber optic sensor system, in-depth study of the cross-correlation function of random signal-based AR model spectrum estimation, designed with the incident detection sensor signal processing algorithms.)

争对移动声源采用波束形成进行语音增强，提出一种约束子带波束形成算法。其波束形成器基于一个软约束，其目的是要使波束指向特定的区域即声源方向。而其核心在于首先要进行声源定位，获得尽量准确的方位信息，然后构造软约束条件，用于波束形成。且在此过程中不断跟踪声源的移动情况。在构造的约束条件中，需要知道声源的二维信息，即与麦克风阵列的距离和方向角，“软”体现在对距离和方向角的确定都是在一定范围内的，有待进一步更正。(Between the mobile sound source using beamforming for speech enhancement, a constrained subband beamforming algorithm. Its beamformer based on a soft constraints, the aim is to make the beam point to a specific region that is the direction of the sound source. And its core is the first to sound source location, access to location information as accurately as possible, and then construct the conditions of soft constraints for beamforming. And in the process continuously tracking the movement of a sound source. Structure at the binding conditions, need to know the two-dimensional sound source information, that is, with the microphone array the distance and direction angle, the " soft" embodied in the distance and direction angle of the determination are within the scope must be further corrected .)