control_gui_matlab_applications

通信系统仿真,QPSK调制与解调,对于matlab初学者以及做通信仿真的人员有很好的参考价值(Communication System Simulation, QPSK modulation and demodulation, for beginners as well as matlab simulation communications personnel to do a very good reference value)

photonic crystal-matlab

电力系统中小电流接地故障仿真，模拟了10KV系统中性点不接地、中性点经消弧线圈两种状态下的电压、电流波形。(Power system small and medium-current ground fault simulation, simulation 10KV system ungrounded, under the two states of the neutral point arc suppression coil voltage and current waveforms.)

GPRMAX2.0中读取geo、out文件的命令。(file command to GPRMAX2.0 in using to read geo&out file.)

一维EKF滤波算法 主要用于目标跟踪 同理可推广到多维情况(ekf object tracking)

sequence code simulation by matlab

plot of the wind turbine

vad（语音活动检测）的matlab代码，采用频域的方法计算信噪比。(vad (voice activity detection) Matlab code, using frequency-domain approach to calculate the signal-to-noise ratio.)

APF SVG matlab souce

An ad-hoc network with a sender, a destination and a third station act- ing as a relay is analysed. The channels are modelled containing thermal noise, Rayleigh fading and path loss. Di® erent combining methods and di- versity protocols are compared. The amplify and forward protocol shows a better performance than the decode and forward protocol, unless an error correcting code is simulated. To combine the incoming signals the chan- nel quality should be estimated as well as possible. Information about the average quality shows nice bene¯ ts, and a rough approximation about the variation of the channel quality increases the performance even more.