GA

STEGANOGRAPHY LSB BY 4 BITS

说明：  matlab键盘输入模型程序，用simulink制作。在7.0以上版本直接运行 运行过程中按一下键盘就会看到示波器上出现一个脉冲信号。(Matlab keyboarding model procedures used Simulink production. In version 7.0 to run over the course of operation under the keyboard will see what appeared on an oscilloscope pulse signal.)

BA_GMRES 内迭代预处理的GMRES(Inner-iteration for GMRES)

基于L阵的二维信号稀疏分解的DOA估计 应用稀疏分解方法进行二维DOA估计(Estimation sparse decomposition method based on two-dimensional signal-dimensional DOA estimation of sparse matrix decomposition L DOA)

利用matlab和ug联合进行齿轮设计，先求解，再建模，思路很新鲜(Ug joint use matlab and gear design, first solved, and then modeling, very fresh ideas)

基于MATLAB的模糊控制，清华大学出版社的某一章节，带程序(Fuzzy control based on MATLAB, a section of tsinghua university press, with the program)

This model using to simulate flicker three phase with full transformer, load.

完整精通MATLAB综合辅导与指南书籍，网上有些缺少前4章。(Full proficiency in MATLAB integrated counseling and guide books, the Internet and some lack of pre-Chapter 4.)

此代码为角点检测程序，可用在对摄像机的标定中获得图像中角点的像素坐标。用MATLAB编写(this code to corner detection procedures can be used in the calibration of the camera image obtained corner coordinates of the pixel. Using MATLAB)

AWGN信道下，基于16QAM的TCM编译码(AWGN channel, 16QAM-based TCM encoding and decoding)