PandO_2

新安江模型参数率定的程序，比较全，我自己试过的，感觉还不错不呢(xinanjiang matlab)

IMPLEMENTATION OF A ROBUST CONTROLLER

对含有噪声滚动轴承振动信号做小波降噪，得到降噪后的波形(Waveform contains noise vibration signals do wavelet noise reduction, reduce noise after)

数独的程序，MCM2008B 可以参考一下(Sudoku procedures, MCM2008B reference)

Formation of Ybus using MATLAB

等幅震荡pid，simulink模块，已经过调试(Amplitude shock pid, simulink module, has been commissioning)

some exercises for Sedumi optimization toolbox

1-32是：图形应用篇33-66是：界面设计篇67-84是：图形处理篇85-100是：数值分析篇(1-32 are: graphics applications, articles 33-66 are: interface design articles 67-84 are: graphics processing chapter 85-100 are: Numerical Analysis Section)

说明：  实现求圆形、三角形、矩形的面积和周长。要求和说明如下： (一) 定义接口sharp接口 (二) 通过实现接口定义Rect、Triangle、Circle的类，并且一个构造方法，并实现求面积和周长的方法（其中三角形斜边的计算公式c=Math.sqrt (width * width + height * height ) ） (Seeking to achieve circular, triangular, rectangular area and perimeter. Requirements and are described as follows: (a) define the interface sharp interfaces (two) by implementing the interface definition Rect, Triangle, Circle of class and a constructor method, and implement methods for the area and perimeter (where the hypotenuse of the triangle formula c = Math.sqrt (width* width+ height* height) ))

ENERGY DETECTION OF SIGNAL