yasuoji

本文档介绍了关于信道仿真的一些程序代码和一些仿真结果，并对各种信道仿真结果做了比较和分析(This document describes a number of channel simulation program code and some simulation results, and a variety of channel simulation result of the comparison and analysis)

基于ARIMA的交通流预测，预测效果相当不错 (Traffic Flow Prediction Based on ARIMA forecast is quite good)

一个单相逆变器，控制环路采用的是MATLAB里面的PID模块，有电流环和电压环，PWM发波模块采用的是MATLAB里面的PWM模块，省去了spwm的脉宽调制，需要在matlab2013中使用，较低版本没法运行(A single-phase inverter control loop uses PID module of MATLAB, current and voltage loop, a PWM wave module adopts the PWM module of MATLAB, eliminating the SPWM pulse width modulation and need to use in matlab2013, lower version did not run)

renewable energy mode for beginers

蜂窝小区资源分配，根据小区间干扰对部分小区进行限制，分配功率和频率资源，实现吞吐量最大化。(Cell resource allocation, according to the inter-cell interference on the part of the cell to limit distribution of power and frequency resources to maximize throughput.)

用斜率的方法来求时间序列的lyapunov exponent,在非线性动力学和时间序列处理中经常用到。很实用的小程序。(slope of the methods used to the time series for the lyapunov exponent. Nonlinear Dynamics and the time sequence processing frequently used. Very small practical procedures.)

matlab算法大全之神经网络，，很不错的资料，较为详细(matlab neural network algorithm Guinness, very good information, more detailed)

MQAM在MATLAB的仿真和图示例程，调试已经通过(MQAM in the MATLAB simulation and icons routines, debugging has been passed)

语音信号的时域波形和频域波形，简单易懂，利用FFT实现。另加语音端点检测文献一篇(Speech signal time domain waveform and frequency domain waveform, straightforward, using FFT to realize )

本程序是关于卫星上下变频的简单的实现算法，首先产生双边带调制信号，与收本振混频后，通过低通滤波器完成下变频。再与发本振混频，通过高通滤波器后完成上变频(This program is a simple algorithm on the satellite and down-conversion, the first double-sideband modulation signal generated, after the close of the oscillator mixer, low-pass filter complete the conversion. Again and send the local oscillator mixer, followed by the completion of the high-pass filter frequency)