LT-code

使用Matlab的M文件编写的数控三轴直线运动代码，为验证DSP上的算法而编(Matlab M-file used to prepare three-axis linear motion of the CNC code, in order to verify the algorithm and the DSP for)

说明：  （蒙特卡洛方法） 求出四分之一圆占正方形的比例。随机投点P(x,y)于正方形，π/4的近似值为落在四分之一圆内的点数与总投点数的比值。随机投点次数分别为10000次和50000次，计算π的近似值。 ((Monte Carlo method) are obtained accounting for a quarter of a round square ratio. Voted random point P (x, y) in the square, π/4 for the fall quarter of the approximation of the points won and the ratio of the total vote points. The number of random points, respectively, voted for the 10000 and 50000 times, the calculation of the approximation of π.)

说明：  灰色预测的实现代码，包括总开始计算到后面的各种检验，残差检验、后验差检验等(Gray prediction code, including the total start to the back of a variety of test, the residual test, a posteriori differential test)

m-CAP pre-equalization for visible light communication

现代通信系统（实用MATLAB)第五章程序(Modern communication systems (useful MATLAB) Chapter V procedures)

说明：  介绍了matlab中的数据归一化，并结合实例分析了归一化具体步骤及用ANN进行预测的方法。(Matlab introduced in the data normalization with examples of the normalized specific steps and methods used ANN to predict.)

gaussnode,gaussquado, mls shap function

雷达系统中用于计算起伏目标的检测概率，适用于Swerling I型目标。(Used to calculate the undulation target detection probability, applies Swerling I target.)

main od the mfile about spot

it is the best programe in matlab you can trait aplication whith the most faimous way bit we cant my you herlp me to do it rait