hough

matlab 的小波包分析（Wavelet packet analysis ）及例程(Wavelet packet analysis )

Most of the algorithms presented in the literature and in this chapter are basically intuitive and are intended to work with ECG signals in accepted clinical conditions, i.e. SNR higher than 18 dB.

本代码实现了通过模糊控制进行倒车的例子，可以完美运行，是智能控制方面学习的好资料。(The code examples performed by reversing the fuzzy control, can perfectly run, is good information intelligent control aspects of learning.)

电池模型，锂离子电池参数估计模型，matlab源代码(battery 1 RC model using in matlab soft)

利用卡尔曼滤波对观测数据进行优化处理，并在观测数据的基础上对卡尔曼滤波进行改进(The Kalman filter is used to optimize the observed data, and the Kalman filter is improved on the basis of the observed data.)

说明：  这个程序和我上传的上一个程序有关，它可以将上个程序收集到的频谱数据进行拼接，从而在全频段进行展示，还能计算频谱上的信号频谱带宽和频点 主要参数 start_freq %扫频中心频率fc的起始频率， stop_freq %扫频中心频率fc的截止频率 rtlsdr_fs %每一次扫频的采样频率，改变他会影响每次扫频的带宽 nfrmhold %每次扫频的帧数 nfft %fft点数 overlap %扫频频谱的重叠率(dataspecrumcatch, catch the spectrum and It can also calculate the signal spectrum bandwidth and frequency point on the spectrum)

CPLEX的MATLAB是一种扩展IBM® ILOG® CPLEX优化器，可以让用户能够定义优化问题，并在MATLAB中解决这些问题。因此，一个学生或谁在使用MATLAB可以轻松解决优化这一框架内的问题。(CPLEX for MATLAB is an extension to IBM® ILOG® CPLEX Optimizers that allows a user to define optimization problems and solve them within MATLAB. Thus a student or practitioner who is using MATLAB can easily solve optimization problems within that framework.)

目标运动模型，三维的和二维的都有，本人毕业设计时候编写的(Target motion model, three-dimensional and two-dimensional of all, I graduated from design time to the preparation of the)

利用matlab模拟光纤中EH11模的模式分布图。(Using matlab simulation mode fiber EH11 mode maps.)

数字信号处理之相关源码集，是学习和应用数字信号处理的MATLAB7.0一些基本的源代码。(Digital signal processing related code sets, learning and application of digital signal processing MATLAB7.0 some basic source code. )