jdwx

这是基于MapX4.0的房屋测绘管理信息系统，直接运行工程文件可以实现。(This is based on the Survey and Mapping MapX4.0 housing management information system, run the project file directly can be achieved.)

PQ分解法，有些还需要改进，该程序所对应的例子是东南大学陈珩编的《电力系统稳态分析（第二版）》的例4-5(PQ decomposition, some also needs to be improved, The procedure corresponding to the example of Southeast University, Chen Heng addendum to the "steady-state power system analysis (second edition)" 4-5 cases)

说明：  PC与PDA数据交互系统 PC与PDA数据交互系统 PC与PDA数据交互系统(Interactive PC and PDA data system PC and PDA Data interactive system Interactive System PC and PDA data)

地震勘探反演方法 正演延拓 假设炮点在地层最底层，向上延拓(Forward seismic inversion method assuming continuation shot in the bottom of the formation, upward continuation)

本软件是一款关于换热器的计算软件，对从事热工计算的朋友有帮助。(This software is a on the heat exchanger calculation software for the calculation of workers engaged in hot friends have helped.)

segy读取原码，该程序是勘探软件必备的代码，有做石油方面项目的一定有用。(SEGY read the original code, the program is an essential exploration software code, so oil projects necessarily useful.)

光伏控制器，自动充放电控制12V/10A光伏控制器（ERA-04-10-A）： 额定工作电压：DC12V 最大充电电流：10A 最大放电电流：5A/路（共两路负载） 太阳能组件开路电压：25V 空载电流：<15mA 温度补偿：-20Mv/°C 工作环境温度：-25°C～+50°C 使用海拔：<5500M 控制器尺寸（mm）: 光控电压（25°C）：<=3.3V 过放保护电压（25°C）：<10.8V 过放恢复电压（25°C）：>10.8V 过充保护电压（25°C）：>15.0V 过压保护电压：17.68V 过压恢复电压：14.7V 浮充电压（25°C）：13.4V～13.7V 恢复正常充电电压（25°C）：13.2V 结束正常充电电压（25°C）：15.0V (PV controller, automatic charge and discharge control 12V/10A PV controller (ERA-04-10-A): Rated voltage: DC12V Maximum charge current: 10A Maximum discharge current: 5A/Road (a total of two loads) Solar components of the open circuit voltage: 25V No-load current: < 15mA Temperature Compensation:-20Mv/° C Operating Temperature:-25 ° C ~+50 ° C with elevation: < 5500M Controller Size (mm): light control voltage (25 ° C): < = 3.3V over-discharge protection voltage (25 ° C): < 10.8V over-discharge recovery voltage (25 ° C):> 10.8V overcharge protection voltage (25 ° C):> 15.0V over-voltage protection Voltage: 17.68V overvoltage recovery voltage: 14.7V float voltage (25 ° C): 13.4V ~ 13.7V back to normal charging voltage (25 ° C): 13.2V end of the normal charging voltage (25 ° C): 15.0V)

测绘领域，该程序为一个边角网平差的程序，能够进行近似计算、间接平差计算，同时能够绘制出测量的网图，进行精度测评。(The field of surveying and mapping, the program for a corner net adjustment procedures can be approximately calculated, indirect adjustment calculation, at the same time able to draw a network diagram, measurement accuracy evaluation.)

说明：  VC++ 6.0调用omron Compolet V2控件与PLC通信 示例(VC++ 6.0 call omron Compolet V2 control)

动态规划的小程序，根据耗水最少，实现水电站发电机组发电机的最佳选择。(Dynamic programming applet, at least according to water, hydroelectric turbines generators to achieve the best choice.)