matlab30chengxudaima

说明：  设基带码元传输间隔为0.1秒，FSK调制参数分别设置频率间隔为5Hz和20Hz，相位分别设置为不连续的和连续的两种。试对比观察4元FSK调制输出等效低通信号的功率频谱。(Let the baseband symbol transmission interval is 0.1 seconds, FSK modulation parameters are set the frequency interval of 5Hz and 20Hz, respectively, set to the discontinuous phase and continuous two. Observation of test 4 yuan FSK modulation output equivalent low pass signal of the power spectrum.)

单相有源功率因数校正电路的数学模型在matlab/simulink中的仿真，仿真已通过。(Mathematical model of single-phase active power factor correction circuit simulation in matlab/simulink the simulation has passed.)

本代码是在MATLAB对于图像进行部分均衡化处理，部分增强图像。(This code is partially balanced in the MATLAB image processing part of the enhanced image processing.)

用matlab编写的muller（抛物线）法求解函数零点(Using matlab written muller (parabolic) Method Function )

说明：  有感知器神经网络实现1与0的识别，输出误差曲线(it is a good program!if you needed,be quick to load it down)

The goal of this program is to demonstrate the construction of a huffman encoding tree. The tree is represented as a binary tree using MATLAB s built in treeplot commands. Contruction of the tree as well as the huffman code book will be described in later sections.

ezw matlab程序，其中包含编码和解码程序(ezw Matlab procedures, which includes encoding and decoding procedures)

huffman算子检测。压缩包解压时没有密码。(huffman operator testing)

500个零件4台车床加工，用动态规划逆序方法求需要的最短时间(dynamic programming backward)

wind energy conversion system connected to grid through matrix converter