Labview_PC_UART

keil uVision软件中实现C8051f单片机调试的配置文件，放在安装目录下(keil uVision SCM software to achieve C8051f debugging configuration files on the installation directory)

说明：  AD1939的数据手册，多通路的模数转换器，ADSP21489板上有(AD1939 data manual, multi-channel analog-to-digital converter, ADSP21489 board)

说明：  此程序是LPC2119两路CAN程序 ，已经成熟用在产品上 并且很稳定(This program is CAN LPC2119 two procedures used in the product is mature and very stable)

利用单片机作为芯片，利用点阵按钮通过继电器控制LED灯(Using single chip microcomputer as a chip, using bitmap button by relay control LED lights)

关于单片机的数码管的控制和显示，有许多的附加功能方便，简单(About the digital pipe of the single chip microcomputer control and display, there are many additional functions is convenient, simple )

上位机发送数据包，下位机实现简单数据接，然后可以存储到其他位置(PC to send data packets, lower machine simple data connection, which can then be stored in a different location)

说明：  msp430单片机的毫伏表程序，四位数码管显示(msp430 microcontroller millivoltmeter program, four digital tube display)

ST的异步串口芯片4通道芯片资料,扩展RS232、RS422、485的好方法(ST16C554 chip uart)

在51开发板上，向AT24C02 EEPROM中写入0x(xx),同时读出之后赋值给P1口。注意三处加*********(In the 51 development board， write 0x (xx)to AT24C02 EEPROM , while after reading assigned to P1 port. Note that three plus。)

说明：  3KW数字llc电源源代码，学习参考。。(3KW Digital LLC Power Source Code)