MLPG_Mixed_Collocation1

信号相位匹配原理的三子真仿真程序。估计信号波形(Signal phase-matching principle of the third son of true simulation program. Estimated signal waveforms)

基于谱聚类分区的matlab程序实现，可以运行。程序给出的是118标准IEEE算例。结果用图形显示很直观，有需要的可以借鉴。(Matlab program based on spectral clustering partition, you can run. The program gives 118 standard IEEE example. The results are graphically displays very intuitive, need to learn from.)

雷达目标检测方法之一的海杂波对消法的仿真例子(Radar target detection in sea clutter simulation example for Consumer Law)

实现正弦波生成的matlab程序，基于矩阵公式推导，可以延伸变化(Sine wave generated by the realization of matlab program, based on the matrix formula is derived, the changes can be extended)

- K means algorithm is performed with different initial centroids in order to get the best clustering. - The total cost is calculated by summing the distance of each point to its cluster centre and then summing over all the clusters.Based on the minimum overall cost achieved during each iteration of iterKMeans the pixel assignment to their respective clusters are made and final compressed image is obtained. This algorithm will run slower as the number of clusters , size of the image and number of iterations increase.

matlab学习资料 简明实例教程 主要介绍了编程的注意事项(matlab learning materials condensed example tutorial introduces the programming Note)

说明：  双向DC，plecs仿真，带闭环控制，可以联合仿真(Bidirectional DCplecs simulation)

>********************************************************************* >This program works with "capacity_plot_main.m" file.Figs >2.6,2.7,2.9,2.12 are determined using this program >SNR is signal-to-noise ratio in dBs >M -> number of antennas (M x M) system >corr -> 1 if with correlation, 0 if uncorrelated (for a 2x2 system only) >value -> correlation coefficient value from 0 ->1 >XPD -> 1 if antenna XPD is to be investigated, 0 if not (for a 2x2 system >only) >alpha -> XPD value >output -> defined by erg and out for ergodic capacity or outage >capacity respectively (>********************************************************************* >This program works with "capacity_plot_main.m" file.Figs >2.6,2.7,2.9,2.12 are determined using this program >SNR is signal-to-noise ratio in dBs >M-> number of antennas (M x M) system >corr-> 1 if with correlation, 0 if uncorrelated (for a 2x2 system only) >value-> correlation coefficient value from 0->1 >XPD-> 1 if antenna XPD is to be investigated, 0 if not (for a 2x2 system >only) >alpha-> XPD value >output-> defined by erg and out for ergodic capacity or outage >capacity respectively )

支持向量机用于分类的一个源程序比较好用的(SVM classificaiton )

matlab code for finite element method