-
FDTD_PBCv1.0_P
用MATLAB编写的利用有限差分时域法仿真电磁带隙天线的代码,非常有用(EBG Antenna analysis based on FDTD using matlab)
- 2009-10-13 09:18:35下载
- 积分:1
-
CA
说明: gps c/a码的产生,是一个小的MATLAB代码,希望对你有用(c/a code generation)
- 2010-05-26 00:37:27下载
- 积分:1
-
matlab6
说明: 《matlab小波分析》第6章的例题的源代码!(" Matlab wavelet analysis," Chapter 6 example source code!)
- 2009-08-11 11:29:08下载
- 积分:1
-
Blind-identification
利用现代谱估计中的AR 模型求取仿真噪声信号和真实噪声信号的模型参数,然后利用这些参数求得信号的功率谱图,通过功率谱图定性地描述主噪声源和次噪声源。在利用信号功率谱图定性描述噪声源后,进一步地利用曲线相似度和曲线关联度定量的识别主噪声源和次噪声源(Use of modern spectral estimation of AR model to strike a realistic simulation of the noise signal and noise model parameters, and then use these parameters obtained by the signal power spectrum, power spectrum qualitatively described by the main noise source and the second noise source. In the use of qualitative description of the noise signal power spectrum of the source, the further use of the correlation curve and the curve of quantitative similarity identification of the main noise source and the second noise source)
- 2011-11-20 22:07:43下载
- 积分:1
-
234567
该程序描述了卫星姿态控制系统所需的欧拉角与四元数间的相互转换关系(The program required for satellite attitude control system is described the mutual conversion between euler angles and quaternions)
- 2013-05-09 17:55:36下载
- 积分:1
-
TCPIP_Communications_in_Matlab
Transmission Control Protocol (TCP/IP) communications are used to send data from one computer to another over a network or from one application to another within a single computer.
The jtcp.m program uses Matlab s ability to call Java code to enable it to send and/or receive TCP packets. One Matlab session can communicate with another Matlab session (on the same machine or over the network) or it can communicate with a completely different program (again, on the same machine or over the network).
The jtcp.m program is basically just a friendly wrapper for Rodney Thomson s "example" TCP/IP code(Transmission Control Protocol (TCP/IP) communications are used to send data from one computer to another over a network or from one application to another within a single computer. The jtcp.m program uses Matlab' s ability to call Java code to enable it to send and/or receive TCP packets. One Matlab session can communicate with another Matlab session (on the same machine or over the network) or it can communicate with a completely different program (again, on the same machine or over the network).)
- 2009-11-15 21:11:40下载
- 积分:1
-
FastEMD-2
快速EMD分解,用了相关距离来解决问题,让算法的运行速度加快(EMD FAST)
- 2010-11-24 17:03:58下载
- 积分:1
-
MIMO_OFDM_key_technology
无线多载波_MIMO_OFDM_系统的理论和关键技术研究,优秀博士论文,做MIMO和OFDM很好的参考(_MIMO_OFDM_ Wireless multi-carrier system theory and key technology research, outstanding doctoral dissertation, MIMO and OFDM make a good reference)
- 2008-06-04 10:00:32下载
- 积分:1
-
tracker-code-2011.04.26
tracker code-tra an ozalp source code good use project in pls
- 2012-02-11 05:05:32下载
- 积分:1
-
rungekuttaprogram
it is a not trusted code
- 2011-02-15 01:54:58下载
- 积分:1