sent-a-signed-int-eger-whit-4-Byte

耀华表通信控件 内置了地磅的串口协议。能自动读取指定的数(Communication control Toledo Electronic loadometer, serial direct source reading program. The source without any Dll, built-in serial port loadometer agreement. Can automatically read the specified binary readings.)

STC12C5A60S2双串口通信例程，含注释。(STC12C5A60S2 Two serial communication routines, including the Notes.)

串口检查源码，VC++工程项目，经典串口通信工具(failed to translate)

RS232的UART编程，包括波特率发生器模块，串口接受模块，串口发送模块(RS232 programming the UART, including the baud rate generator module, serial module to receive, send serial module)

清除串口冗余。当下位机偶然有乱码出现时，在新的通讯开始先清除缓冲区冗余信号，然后开始通讯，可以保证通讯更稳健(Clear serial redundancy. Current-bit machines have occasionally garbled when, in the new communications start to clear the buffer zone redundant signal, and then began to communications, to ensure more robust communication)

使用perl实现简单的串口通信；在串口上循环读写命令，可用于对串口通信的压力测试；(Using perl simple serial communication read and write commands on the serial loop, can be used for serial communication test pressure )

说明：  电容感应按键，（TWO KEY）检测程序，串口通信和CRC校验。(Capacitive sensing buttons, (TWO KEY) testing procedures, serial communications, and CRC check.)

用 C++ 编写的 发送 接收串口工其软件，好用，可以参考一下(C++ prepared by the transmission and receiving serial software, good use, you can refer to)

说明：  机器人小车串口通讯程序，采用stm32单片机，供大家交流(Serial Communication Program of Robot Car for Communication)

C# 写的串口通信程序源码,MODBUS RTU(C# to write the serial communication program source code, MODBUS RTU)