PLC-OFDM

基于VC++ 6.0 Winsock+UDP 广播信息源码(Based on VC++ 6.0 Winsock+ UDP broadcast source)

一个详细讲述卡尔曼滤波的ppt，通过它可以学习有关卡尔曼滤博，和机器人自主定位的知识( Kalman filter detailed ppt, through which you can learn more about Bo Kalman filter, and knowledge of robot autonomous localization )

说明：  ：载波频率偏移是OFDM系统实现的关键问题之一。分析了OFDM 系统载频偏移估计的2 种算法，即利用循环前缀和训练序列方法。它们均为最大似然估计方法。分别讨论了它们的基本 思想、实现方法和仿真结果。可以看出基于循环前缀算法复杂度较小，精度不高，而基于训练序列 的算法有较高的估计精度，但降纸了系统传输效率。(Abstract：Carrier frequency ofset is one of the key problems in OFDM system．Two foundational methods 。cycling prefix—based and training sequence—based algorithms。to estimate OFDM carriers~equency ofset are analyzed．Then it discusses their basic thoughts。implementing methods and simulation resuits． Finally。merits and demerits of every algorithm are supposed．It concludes that the cycling prefix— based algorithm has less complexity and less precision。and that the training sequence—based algorithm has better estimation performance at the cost of transmission efficiency．)

说明：  document qpsk vhdl code

PCM文件采样率转换，其中可以自己定义采样率。作为WAV文件进行存储。效果较好。注意使用时确定源文件采样率。(PCM file sample rate conversion, which could define their own sampling rate. As a WAV file is stored. Effective. Note that when used to determine the source file sample rate.)

MIMO系统的ZF和MMSE预编码算法-4发4收(ZF and MMSE MIMO system pre-coding algorithm-4 of 4 admission)

说明：  h5聊天室仿红包群微信群源码，可以发红包，做一个网站版的聊天室。(H5 Chat Room Micro Message Group Source Code Imitating Red Packet Group)

socket 编程(socket programming)

利用C++实现的一个即时通讯系统的客户端。传输层采用的是TCP协议。这是本科时候的毕业设计，最后评定为优，希望对一些朋友能有所帮助。(The use of C++ implementation of an instant messaging system client. Transport layer protocol used is TCP. This is the time of undergraduate graduation project, and finally classified as gifted, in the hope that some of my friends can be helpful.)

ADIBEAM Abstract—the increase in navigation accuracy demanded by EGNOS and Galileo and their future evolution encourages the study and design of advance receiver architectures. In that direction, the ADIBEAM project focuses on the design of high accuracy ground stations, specifically GNSS Reference Stations, in order to improve its robustness in front of multipath and interference errors with the goal of achieving centimeter level tracking accuracy. The adoption of antenna arrays and digital beamforming at the ground reference station receivers is one of the most promising approaches to cope with errors induced by multipath and interference.