-
StepMotor1
步进电机失步情况的一个仿真.这是一个比较完整的方针,但是仅仅考虑了在单个脉冲下的失步情况.(Stepper motor out-of-step situation in a simulation. This is a relatively comprehensive approach, but considered only in a single pulse under the out-of-step situation.)
- 2007-11-22 08:31:36下载
- 积分:1
-
capture_interface
Just a few functions used in my other toolboxes, for computing MSE and PSNR and some other less common image quality metrics.
- 2014-02-17 08:04:50下载
- 积分:1
-
Practice2
说明: 车厢调度:程序对栈的任何存取(即更改,读取和状态判别等操作必须借助于基本操作。(Train scheduling: proceedings of the stack of any access (that is, changing, reading and state identification must be by means of basic operations such as Operation.)
- 2010-04-03 11:19:49下载
- 积分:1
-
Potential_Flow_Simulator
flow simulation with 2D mesh
- 2011-05-10 01:37:31下载
- 积分:1
-
csa
免疫克隆算法优化函数的程序,matlab环境下实现(Immune clonal algorithm to optimize the function of the program under the Matlab environment)
- 2012-05-26 21:56:06下载
- 积分:1
-
Gabon-Filter
Image Processing with Gabon Filters
- 2014-12-23 05:17:15下载
- 积分:1
-
MATLAB
matlab入门ppt,第一章,对于需要学习matlab入门的同学很有帮助。(matlab entry)
- 2013-09-14 20:09:34下载
- 积分:1
-
Optimization-of-fuzzy-control
Optimization of a gas turbine engine fuzzy control
- 2013-11-13 15:07:36下载
- 积分:1
-
stop-and-wait
Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.
- 2011-08-03 16:52:09下载
- 积分:1
-
budengbanjinfangzhendaima
不等半径泊车方法仿真代码,实现不等半径泊车算法的仿真,车辆参数如车长、车宽、转弯半径以及车位参数如长度、宽度均可调。(Simulation code radius ranging from parking way to achieve a radius ranging from parking the simulation algorithm, vehicle parameters such as vehicle length, vehicle width, turning radius and parking parameters such as length, width can be adjusted.)
- 2021-03-25 15:39:14下载
- 积分:1