Hu_MV_Nicolas

说明：  本程序是基于马尔可夫链蒙特卡尔理论的贝叶斯工具。版本为MCMC Methods for MLP and GP and Stuff (for Matlab) V2.1 (A collection of matlab functions for Bayesian inference with Markov chain Monte Carlo (MCMC) methods. The purpose of this toolbox was to port some of the features in fbm to matlab for easier development for matlab users. )

用MATCOM实现VC_对MATLAB中_m文件的调用(With MATCOM achieve VC_ on file in MATLAB call _m)

说明：  Jafarkhani的差分空时分组码matlab程序，在不同信噪比下，比较了系统SER和BER。采用2发1收，瑞利衰落信道(Jafarkhani differential STBC matlab procedure, at different signal to noise ratio, the system compares the SER and BER. The use of 2-fat one admission, Rayleigh fading channel)

说明：  自适应控制算法的另一个Simulink模型，可运行，是无模型参考控制算法的一个应用实例，供共同学习和交流(Adaptive control algorithm to another Simulink model to run, there is no model reference control algorithm of an application example for the common learning and exchange)

Another file of actuator example.

MATLAB模型，双馈风电机组基于最大功率跟踪，低风速超速控制，中风速高风速变桨距控制(DFIG MATLABThe wind turbine and the doubly-fed induction generator (WTDFIG) are shown in the figure called The Wind Turbine and the Doubly-Fed Induction Generator System. The AC/DC/AC converter is divided into two components: the rotor-side converter (Crotor) and the grid-side converter (Cgrid). Crotor and Cgrid are Voltage-Sourced Converters that use forced-commutated power electronic devices (IGBTs) to synthesize an AC voltage from a DC voltage source. A capacitor connected on the DC side acts as the DC voltage source. A coupling inductor L is used to connect Cgrid to the grid. The three-phase rotor winding is connected to Crotor by slip rings and brushes and the three-phase stator winding is directly connected to the grid. The power captured by the wind turbine is converted into electrical power by the induction generator and it is transmitted to the grid by the stator and the rotor windings.)

Van der Pol Oscillator (chaotic map)

动态K-S检验边缘分布的copula 分布估计算法( Marginal distribution in copula estimation of distribution algorithm based dynamic K-S test)

A band pass filter designed

离散点曲线 进行3次B样条曲线拟合 包括节点参数化过程 基函数计算过程 控制点反求过程 到最后拟合曲线的显示(The discrete point curve is fitted with 3 B spline curves, including the node parameterization process, the basis function calculation process, the control point inversion process, and the final fitting curve display)