chirp-signal

Generate mesh for finite element

用matlab仿真来实现QPSK通信系统(Matlab simulation of QPSK)

改良的离散余弦变换MDCT,可用于MP3编解码过程中的MDCT使用。(modifed discrete cosine transform)

mesh power flow& math

维纳噪声抑制；实验分析；实验结果及分析；利用信号之间的相关性进行信号估计，从而将噪声滤除(Wiener noise suppression Experimental analysis The experimental results and analysis Using the signal signal to estimate the association between, to filter out noise )

程序对2发2收系统进行SVD算法的仿真。发送信号采用QPSK调制，信道为准静态瑞利平坦衰落信道，引入的噪声为均值为0的高斯白噪声，接收端采用最大似然检测算法，仿真其误比特率特性。(The SVD algorithm simulation program 2 admission system. Send signals using QPSK modulation, channel prevail static Rayleigh flat fading channels, the introduction of noise with mean 0 Gaussian white noise, the receiving end using the maximum likelihood detection algorithm, simulation of the bit error rate characteristics.)

Gonzales的书数字图像处理matlab版的 源代码(matlab codes of image processing by Gonzalez)

balanis antenna code part5

能量收集双向中继的联合功率分配的中继选择算法(relay selection method of energy harvesting two-way relay network)

说明：  VS中开发的一个C与matlab混合编程的小程序，该类可以使用到其他的MFC程序中去。 但是注意，使用时，要把matlab所在的本地文件夹中的extern中的lib和include添加到VS的工程属性的lib和include路径中去。且要添加四个lib文件。(VS in the development of a mixed C and matlab programming small programs, the class can use the program to other MFC to. Note, however, when used, should matlab local folder where the extern in the lib and include added to the VS project properties go to lib and include paths. And to add four lib.)