ldpc_decode_logforOFDM

Multiuser OFDM with Adaptive Subcarrier, Bit, and Power Allocation BY- J.Yashashchandra.Rao (jyashashchandra@yahoo.com)

杰理得蓝牙通讯程序，可用于蓝牙和FM音箱的开发。(Bluetooth Communicator)

是硕士论文里面的关于NAKAGAMI信道的代码,MATLAB写的,大家可参考(There is a master)

采用滤波器组，将盲分离与声源定位结合在一起。滤波器组中分别进行子带处理，并且在每个子带中进行声源定位，最后综合所有子带估计的方向得到多个声源的方位信息，同时将声源信息作为ICA分析的约束条件，可以在色噪声及多得到更好的盲分离效果。其优势在于用滤波器组进行多次的估计声源方向，再加以合适的权值均衡后即可得到更优的估计。(The use of filters will be blind source separation and sound localization together. Filter group were sub-band treatment, and in each sub-band in Sound Source Localization, and finally all the sub-band is estimated to be more than the direction of sound source location information, as well as sound source information as ICA analysis of the binding conditions, colored noise can be better and many of the blind source separation effect. Its advantage lies in a number of filter banks with estimated sound source direction, coupled with an appropriate balance weights can be obtained after the better estimate.)

主要介绍空中接口物理链路层的无线技术，共分三个部分，首先对主要接口和协议作 简单介绍和描述；然后分别介绍信道与帧；无线信道编码与交织以及LAPDm。(Mainly introduces Wireless technology of air interface in the physical link layer which is divided into three parts. first: a brief introduction and description of the main interfaces and protocols then:Road and frame and last radio channel coding and interleaving and LAPDm .)

8*4的信道生成，mimo仿真时推荐使用。(8*4 channel generation, MIMO simulation recommended use.)

说明：  opnet仿真tdma 编程 很适合基本的学习(opnet tdma simulation)

实现ldpc 编译码功能，并且输出BER和曲线图。(LDPC encoder and decoder)

无线信道建模一直以来都很复杂，而且不同场景下的模型差异较大，这是一本专门讲解无线信道建模方法的书籍配套的matlab例程(Channel modeling has been very complex, and the model under different scenarios are quite different, which is the one devoted to channel modeling method books matching matlab routines)

天线组阵中基于循环相关的BPSK信号合成方法研究(Antenna array study group cycle related BPSK signal synthesis method based on)