登录
首页 » matlab » KNN

KNN

于 2010-05-03 发布 文件大小:1KB
0 218
下载积分: 1 下载次数: 1

代码说明:

说明:  自己的模式识别的作业,matlab实现k近邻算法。(K-Nearest Neighbour algorithm)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • svm_inverter_anggun_anugrah
    This is a simple model simulink for Space Vector Pulse Width Modulation Inverter with input alpha-beta (2-phase AC)
    2010-05-11 11:34:46下载
    积分:1
  • GMSK
    GMSK也是通信中的重要内容,用MATLAB仿真的源程序代码(GMSK is also an important part of communication, the source code using MATLAB simulation)
    2011-11-22 13:33:24下载
    积分:1
  • system-modeling
    包括银行ATM机的离散时间动态系统的建模仿真,蒙特卡洛方法求π,军备竞赛问题仿真等,均包括问题的分析,源程序,结果分析等(Including bank ATM machine of discrete-time dynamic system modeling and simulation, the Monte Carlo method for π, the arms race simulation, including the analysis of the problem, source, results analysis)
    2012-11-01 09:58:42下载
    积分:1
  • pq
    说明:  谐波检测基于瞬时功率的pq法,检测电流谐波分量图(Harmonic detection based on PQ method of instantaneous power to detect current harmonic component diagram)
    2020-04-04 21:16:09下载
    积分:1
  • ixty232
    structure to store a complex number (consisting of real and complex part) and features addition, multiplication, and outs of complex numbers.
    2014-08-22 21:28:33下载
    积分:1
  • Matlab与VC方法
    说明:  matlab应用越来越广泛。但如何与VC 结合来提高编程效率呢,本文提供的资料可以帮大家。(matlab application is more and more widespread. How but unifies with VC enhances the programming efficiency, this article provides the material may help everybody. )
    2005-09-26 22:34:32下载
    积分:1
  • power_switch
    power_switch.rar,功率电子领域matlab仿真文件,已经验证过,程序运行正常(power_switch.rar, Power electronics field matlab simulation file, has already been verified, the normal operating procedures)
    2013-07-14 12:45:26下载
    积分:1
  • withoutsatcom
    without dstatcom. here non linear load and star connected loads are used to generate the harmonics
    2012-09-22 16:51:27下载
    积分:1
  • 793666757crosscorr
    matlab编写的点阵计算程序,用于阵列全息光镊的计算(spot array calculation)
    2020-07-23 16:28:43下载
    积分:1
  • Newton
    说明:  用牛顿下山法求解方程:下山因子在计算过程中可以变动,一般选择下山因子时从1开始,逐次将减半进行试算,直到能使下降条件成立为止。若当计算到某步时取不到满足要求的值(或值小到无法容忍),这时称“下山失败”,需要另取初值重新算起。(Descent method with Newton' s equation: down factor in the calculation process can change, usually selected from the 1 start down factor, will be halved for successive spreadsheet until the can down the conditions established. If when calculating the time to take a step not meet the requirements of the value (or values ??too small to tolerate), then the &quot down failed&quot , you need an alternative initial re-counting.)
    2011-03-16 16:54:30下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载