JAVAshouji

说明：  c++源程序代码 c++源程序代码(source code c c c source code source code)

这是一个相对完整的OFDM通信系统的仿真设计，包括编码，调制，IFFT， 上下变频，高斯信道建模，FFT，PAPR抑制，各种同步，解调和解码等模 块，并统括系统性能的仿真验证了系统设计的可靠性 (OFDM full version of the source code, including coding, modulation, IFFT, Upper and lower frequency, Gaussian channel model, FFT, PAPR suppression, a variety of synchronization, demodulation and decoding module, and system performance of the omnibus simulation verify the reliability of the system design)

对信号进行滤波，频谱分析，以及对滤波器的特性进行分析（基于labview的高级信号处理工具箱）(Filtering, spectrum analysis, and analysis of filter characteristics (advanced signal processing toolbox based on labview))

Photovoltaic systems, solar thermal systems based on knowledge training(PVSystem)

心电信号去噪方法等研究，采集，去除噪声等(Research on the denoising method of ECG signal, collection, noise removal, etc.)

基于利尔达2F717N30模组，实现收发互传,MSP430平台(lierda lora module tx or rx base by msp430)

匹配滤波器的实现。主要是通过fft变化使输出自相关最大，在通过滤波器。(Matched filter implementation. Mainly through changes in the output autocorrelation fft the largest through the filter.)

OPNET仿真的无线信道，OPNET仿真的无线信道

Modbus协议及Modbus RTU的C51编程(Modbus RTU Modbus protocol and the C51 programming)

用UWB技术实现定位的程序，定位精度高达10cm，STM32作为主控单元(UWB technology to achieve positioning procedures, positioning accuracy of up to 10cm, STM32 as the main control unit)