quedinginhaopinpufenxi

RLS matlab code which means Recursive lease square algorithm

说明：  根据过完备原子库中原子的能量分布特性创建大小原子的Matlab程序。(Over-complete atoms according to the Treasury in the distribution of atomic energy to create the size of atoms Matlab procedures.)

这是用C语言编写的机动目标跟踪程序，用matlab仿真实现的。直接用于机动目标跟踪仿真。(This is written with C language target tracking procedures implemented with the matlab simulation. Directly used for maneuvering target tracking simulation.)

地震波转换与ANSYS应用工具及示例。 采用美国加州大学的地震波数据库，然后进行数据库数据的分析，最终得到可以应用到ANSYS中的地震分析输入数据(Conversion of seismic waves with the the ANSYS application of tools and examples. University of California seismic waves database, and then proceed to the analysis of the data from the database, the final seismic analysis of input data can be applied to ANSYS)

power wind generation

1.边缘检测，分别用Sobel, Laplacian-Gaussian 方法对一幅灰度图像进行边缘提 取，并给出对比结果； 2.灰度阈值分割：利用双峰法对一幅灰度图像进行灰度分割处理。(1. Edge detection, respectively Sobel, Laplacian-Gaussian methods on a gray-scale image edge extraction, and gives comparative results 2. Gray threshold segmentation: Using Twin Peaks method a gray image gray-scale be dealt with separately.)

This is a Buck Boost Converter Simulation in MATLAB Simulink.

利用MATLAB对信号进行FFT处理，观察幅频响应和相频响应(FFT using MATLAB for signal processing, observed amplitude frequency response and phase frequency response)

说明：  Genetic algorithm implementation

说明：  快速傅里叶变换 (FFT) 实现，给定信号x(t)=sin(2πf0t)，f0=50Hz，对x(t)以fs=200Hz进行抽样，抽样点数为N=16。编写程序实现对x(n)的快速傅里叶变换，求得相应的X(K)。(Fast Fourier Transform (FFT) to achieve a given signal x (t) = sin (2πf0t), f0 = 50Hz, for x (t) with fs = 200Hz sampling, the sampling points is N = 16. Procedures for the preparation of x (n) of the fast Fourier transform, obtained by the corresponding X (K).)