12864

MSP430G2553单片机与LCD1602显示模块和4x4矩阵键盘实现的电子秤控制系统（无AD数据采集部分） (MSP430G2553 SCM and LCD1602 4x4 matrix display module and electronic scales keyboard control system implemented (no AD data acquisition section))

说明：  LCD1602和74LS164的电路图，还有完全的C语言代码，附加上了仿真原文件。(LCD1602 and the 74LS164 in the schematics, as well as the complete C language code, additional on the simulation of the original document.)

现代单片机驱动矩阵键盘，通过UART口收发键值(ABOV MCU drive matrix keyboard, send and receive key value through UART port)

英飞凌SP12压力传感器与单片机C51的通讯程序 实现SPI串口通讯 (Infineon SP12 pressure sensor C51 microcontroller communication with SPI serial communication program)

stm32数组转二进制工具，在Keil下运行 1.输入文件内容必须包含类似于{0xff,0xff}这样的c语言数组格式，才能正常转换。大括号和前导符“x”是必须的。 2.支持8位和16位数据。 3.支持4个字节的长宽信息，方便Image2Lcd程序输出的图片转换成Bin。 4.支持成对“/”符号包含注释信息，若文件内容只有单个“/”,后果自负。 5.支持头四个字节的宽高信息互换存储位置。(stm32 array to binary tools, running in Keil 1 input file must contain similar {0xff, 0xff} c language such array format to normal conversion. Braces and leading character "x" is a must. 2 supports 8-bit and 16-bit data. 3 supports 4-byte length and width information to facilitate Image2Lcd program output image into Bin. 4 support paired "/" symbol contains annotation information, if only a single file contents "/" peril. 5 support the first four bytes wide exchange of information stored in a high position.)

本内部诊断故障码，详细规定了新能源汽车关于BMS，MCU等规章码(This internal diagnostic fault codes, detailed rules on the new energy vehicles about BMS, MCU and other rules and codes)

// This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-wire Single Master Mode, and the EEPROM is the only // slave device connected to the SPI bus. The read/write operations are // tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware // connections of the F06x MCU are shown here:

ansys导入到adams中做刚柔耦合动力学分析，采用的是梁单元，希望对大家做刚柔耦合动力学分析有所帮助(ansys and adams are work together)

提高LCL型并网逆变器鲁棒性的电容电流即时反馈有源阻尼方法(Improve the LCL type grid inverter robustness of capacitive current instant feedback active damping method)

时钟芯片CW1288的驱动程序，适合外挂时钟的系统(CW1288 clock chip driver for external clock system)