登录
首页 » LabView » Packet-Sniffer-Example1

Packet-Sniffer-Example1

于 2011-04-04 发布 文件大小:427KB
0 292
下载积分: 1 下载次数: 0

代码说明:

说明:  TCP/IP通信截取指定IP和port的数据包(packet sniffer)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 370511
    psk调制,在matlab命令区输入bpskdigital[1 0 1 1 0 0 1 0],1]按运行,即可看到调制波(Psk modulation, input bpskdigital [1 0 1 0 0 0] in the matlab command area, 1] press operation, you can see the modulation wave)
    2019-03-26 23:08:40下载
    积分:1
  • dfsdfgsdtgregdfs
    OFDM程序 波形如下 子载波数 128 % 位数/ 符号 2 % 符号数/ 载波 100 % 训练符号数 0 % 循环前缀长度 8 (1/16)*T % 调制方式 4-QAM % 多径信道数 3 %IFFT Size 128 % 信道最大时延 2(OFDM waveform procedures following subcarriers median number of 128%/2% Symbol Symbol/Carrier 100% Training a few symbols 0% cyclic prefix length 8 (1/16)* T% modulation 4-QAM% multi-path channel number 3% IFFT Size 128% maximum delay Channel 2)
    2007-06-12 19:52:33下载
    积分:1
  • OSPA_for_Tracks
    OSPA 距离计算 用于多目标检测使用的方法。 一键计算OSPA距离。使用前请仔细阅读readme 文件。严格按照步骤操作。(OSPA distance calculation. Perfect solution for OSPA calculation. Make sure you go through the read me file before using it.)
    2020-11-06 10:39:50下载
    积分:1
  • MIMO_GMD
    对MIMO中GMD预编码性能进行仿真,采用基于QR分解的检测方法。(Simulation of GMD precoding performance in MIMO)
    2017-12-11 15:56:55下载
    积分:1
  • gray_counter_vhd
    ldpc verilog code has been descripted in this program
    2017-12-06 01:05:36下载
    积分:1
  • QPSK_AWGN_GRAy_ErrorCalculate
    信息经格雷码映射,进行QPSK调制并通过AWGN信道发射,在接收端进行QPSK解调,并统计误符号率和误码率。(Information on the Gray code mapping, QPSK modulation and emission through the AWGN channel, QPSK demodulator at the receiving end, and the statistical symbol error rate and bit error rate.)
    2012-05-11 10:27:46下载
    积分:1
  • B11Test
    一种Ipod Shuffle Cable检测程序(One kind of Ipod Shuffle Cable testing procedures)
    2011-10-28 08:46:13下载
    积分:1
  • path loss
    无线信道建模,路径损耗及正态阴影模型源代码,可出图,(Path loss Wireless channel modeling)
    2019-05-07 17:39:48下载
    积分:1
  • OFDM信号频谱感10
    说明:  前已提出的频谱感知方法主要包括匹配滤波器检测、 能量检测、 循环平稳特征检测以及多分辨率频谱感知. 这些方法均为单节点感知方法.然而,在阴影和深度衰落情况下, 单个节点的感知结果并不可靠, 因此, 需要对多个节点的感知结果进行融合,以提高检测可靠性, 即协作感知技术. 文献采用“或” 准则对各个 CR 感知结果进行融合. 文献则提出了基于 D-S 证据理论的协作频谱感知算法,虽然该算法的性能比“或” 准则或“与”准则要好, 但需要存储大量历史信息, 算法的计算复杂度也很高. 文献中分析了采用似然比检测(likelihood ratio test, LRT) 的软判决与采用“与” 准则的硬判决的性能, 结果表明采用软判决的协作感知性能更优(Previously proposed spectrum sensing methods mainly include matched filter detection, energy detection, cyclostationary feature detection and multi-resolution spectrum sensing. These methods are all single node sensing methods. However, in the case of shadow and deep fading, the sensing results of single node are not reliable, so, It is necessary to fuse the sensing results of multiple nodes to improve the detection reliability, i.e. cooperative sensing technology. In the literature, "or" criterion is used to fuse the CR sensing results. In the literature, a cooperative spectrum sensing algorithm based on D-S evidence theory is proposed. Although the performance of the algorithm is better than "or" criterion or "and" criterion, a large amount of historical information needs to be stored, The computational complexity of the algorithm is also very high. In the literature, the performance of the soft decision based on the likelihood ratio test)
    2020-11-19 21:19:37下载
    积分:1
  • STM32加ESP8266基础工
    说明:  STM32对接ESP8266的驱动,测试MQTT通讯和测试TCP通讯(STM32 TO ESP8266,test MQTT communication and test TCP communication)
    2020-06-02 16:09:54下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载