51

说明：  串口控制c源代码，自己看看，根据例程改的(Serial port control C source code)

中控指纹5.0SDK，指纹开发包。Zk Finger SDK 5.0(ZK Finger SDK 5.0 Demo)

电协开发板 C51单片机程序，用于实现单片机的流水灯输出(Electric Association C51 microcontroller development board procedures for the realization of single-chip light water output)

说明：  ST7920带中文字库液晶原码程序 12864 keil的，串行方式 编写时已经考虑到往avr上的移植了，spi可以用avr硬件的，也可以用io模拟，甚至可以用mega48的串口做spi主机 ，经过我的测试串行方式，在cs无效时，7920还是可以接受数据，导致显示被误改，如果spi上接了其它器件，小心使用。(Driver with the original Chinese font LCD procedure code 12864 Keil. Serial way has been prepared to take into account the transplant avr, 20 avr hardware can be used, io can also use the simulation, or can even be done Serial mega48 20 mainframe, I have serial testing, cs in vain, 7920 can still receive data, resulting in the misuse of reform shows that if 20 on to other devices, careless use.)

周立功的nxp lpc1114adc转换例程 中断模式转换模式 内含串口通信 adc转换(zlg nxp lpc1114adc conversion routines interrupt mode conversion mode adc conversion includes serial communication)

DS27xx系列的代码，库仑计测量电量的，（最好能够使用DS2780K来直接设置）(DS27xx series of code, coulometric meter measuring the amount of electricity (preferably by using DS2780K to set it directly))

液晶例程， 包括画点画线画缓冲条，在液晶上printf的算法(LCD program world，you can study LCD draw points )

梦幻WAS提取源码程序位图的结构，使用置入汇编代码的方法实现提取梦幻WAS资源。(Fantasy WAS extraction structure of the source program bitmap into assembly code using methods to achieve the dream WAS resource extraction .)

$regfile = M8DEF.dat internal crystal 8000000 Config Lcdpin = Pin , Db4 = Portc.1 , Db5 = Portc.2 , Db6 = Portc.3 , Db7 = _ Portc.4 , E = Portd.2 , Rs = Portd.3 Config Lcd = 16 * 2 Config Timer1 = Counter , Edge = Rising Ddrb.1 = 0 : Portb.1 = 1 PULL UP RESISTOR ACTIVATED Config Timer0 = Timer , Prescale = 1024 Enable Counter1 Enable Interrupts Enable Timer0 Enable Timer1 On Ovf1 Pulsecount On Ovf0 Ovf0occures Dim A As Long , I As Long , B As Byte B = 0 Cls Start Timer0 Do Loop End end program Ovf0occures: Incr I If I > 30 Then Stop Timer0 Cls : Home A = B * 65536 A = A + Counter1 Lcd FREQ IS : A HZ B = 0 I = 0 : Counter1 = 0 Start Timer0 End If Return Pulsecount: Incr B Counter1 = 0 Return

s7300程序 MODBUS 通讯处理的一段程序(s7300 PROGRAM)