signal_process

利用matlab进行信号采样（欠采样、过采样等）的源程序(Sampling the signal using matlab (less sampling, oversampling, etc.) of the source)

plotting training data from the "unknown function" G(x,z)

说明：  这些程序是MIT学生学习Matlab时的教学程序，能面还有个pdf文档附有每个程序所实现的功能(This is the teaching codes at MIT for learning Matlab. hope it is helpful for you.)

系统辨识及其MATLAB仿真，侯媛彬，科学出版社，介绍了各种辨识方法的MATLAB实现(System identification and MATLAB simulink)

DICOM to NIfTI converter by Xiangrui Li

说明：  本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之 上，提出了基于FMIPv6的WIMAX网络快速切换机制，该方案采用跨 层切换的思想，MAC层联合网络层同时进行切换，在链路尚未断开 之前即完成新转交地址(NCOA)获取等功能，从而加快了切换进程， 减小了切换时延和切换时的丢包率。在提出本切换机制的基础上，本 文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真，通 过仿真结果验证了方案的可行性和优越性。 ( In this paper, IEEE802.16e standard is described at first. Then an introduction for the basic knowledge and research in MIPv6 and FMIPv6 protocol is given. A fast handover scheme of WiMAX network which based on FMIPv6 protocol is suggested, which implements the fast handover at IP layer associating with MAC layer at the same time. scheme minimizes handover latency by predicting and preparing This the impending handover in advance. Finally, simulation are carried out to evaluate the performance of this fast handover scheme. The result of the simulation shows that the fast handover scheme has good performance. )

功能为neighborhood components analysis，a quick matlab implementation of NCA (see Goldberger et al, NIPS04). (err)

GABOR滤波器的设计程序.两个程序，都是基于matlab实现。(GABOR filter design process. The two procedures are based on matlab to achieve.)

无线通信原理与应用这本书上的第153页的仿真程序，根据J.I.smith的论文编写的(J.I.smith code for rayleigh-fading-code)

使用MATLAB语言进行曲波变换, 含有MATLAB语言曲波变换函数及所有原程序(Qu Bo transformation using the MATLAB language, containing MATLAB language Qu Bo transformation function and all of the original program)