M,GOLD ,WALSH序列自相关和互相关的仿真代码

模糊滑模控制的matlab仿真，希望对大家有用(Fuzzy Sliding Mode Control of matlab simulation, in the hope that useful to everybody)

说明：  实现了对函数的奇偶分频的频谱分析，DFT什么的，包括了4个基础的信号处理实验代码(To achieve parity of function analysis of frequency spectrum)

this file is matlab code for simulating msk modulation

Matlab图像处理基本操作及摄像机标定(Calibration of Matlab camera and image processing basic operation)

the code file that is uploded is rfft file

solution for newton raphson load flow analysis

说明：  图像处理案例，本程序是用matlab基于形态学的权重完成自适应图像去噪功能(Image processing case, this program is based on the weight of MATLAB morphology to complete adaptive image denoising function.)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

正交空时分组码误码率的性能分析，可以对在无线传输信道下的源信号进行编码，使其更加适合信道传输(Orthogonal STBC BER Performance Analysis)

maltab语言编写的MIMO仿真程序。程序中采用双天线发射，单天线接收，通过瑞利信道，计算误码率并绘图。(maltab language MIMO simulation program. Procedures used in the dual-antenna, single-antenna receiver, through the Rayleigh channel, bit error rate calculation and drawing.)